BorMann PRO BBS4010 Mode D'emploi page 9

EN
PROPER USE
The portable metal band saw with speed se ng is exclusively suited for cu ng wood, pipes, profi les and thin non-ferrous metals. The shape of the workpieces
must be such that safe clamping in the machine vice is possible and such that the workpiece is prevented from jumping out during the sawing process. Only
saw bands that are suitable for the machine may be used.
An element of the intended use is also the observance of the safety instruc ons, as well as all assembly instruc ons and opera ng informa on in this manual.
Persons who operate and maintain the tool must be familiar with the manual and must be informed about poten al dangers. The power tool may only be
used by personnel who have been trained to use it and who have been instructed with respect to the associated hazards. The required minimum age must be
observed.
In addi on, the applicable accident preven on regula ons must be strictly observed. Other general occupa onal health and safety related rules and regula ons
must be observed. The user must also comply with all na onal regula ons applicable to the opera on of the power tool.
The machine may only be used in the intended manner. Τhe manufacturer of this device assumes no liability for damage to the device or caused by the device
arising from:
• Improper handling,
• Failure to comply with the opera ng instruc ons.
• Repairs carried out by third par es, unauthorised specialists.
• Installing and replacing non-original spare parts.
• Applica on other than specifi ed.
SPECIFICATIONS
Main Parts (Fig. 1 - 3)
1. Handle
2. Motor
3. LED light on/off switch
3.1. LED light
4. Speed se ng wheel
5. On/off switch
6. Release switch
7. Handle
8. Power cable
9. Saw band guard (le /right)
10. Workpiece stop
11. Saw band
12. Metal band saw holes
13. Tightening lever for saw band
14. Top saw band guard
15. Carbon brushes
16. Saw band drive unit
17. Rubber belts
18. Guide rollers
19. Support arm
20. Support arm holes
21. Saw table
22. Support arm base plate
23. Fixed clamping jaw
24. Moving clamping jaw
25. Workpiece clamping lever
26. Locking handle (graduated scale)
27. Safety bolt
* The manufacturer reserves the right to make minor changes to product design and technical specifi ca ons without prior no ce unless these changes
signifi cantly aff ect the performance and safety of the products. The parts described / illustrated in the pages of the manual that you hold in your hands may
also concern other models of the manufacturer's product line with similar features and may not be included in the product you just acquired.
* To ensure the safety and reliability of the product and the warranty validity, all repair, inspec on, repair or replacement work, including maintenance and
special adjustments, must only be carried out by technicians of the authorized service department of the manufacturer.
* Always use the product with the supplied equipment. Opera on of the product with non-provided equipment may cause malfunc ons or even serious
injury or death. The manufacturer and the importer shall not be liable for injuries and damages resul ng from the use of non-conforming equipment.
9
Technical Data
Model
Voltage
Power
No-load speed
Band saw blade
Cu ng Ability
Weight
Cable Length
Includes
Scope of delivery
• 3 Hexagon socket screws
• 1 Hexagon socket screw + nut
• 2 Allen keys
• 1 Saw blade
• 1 Pair of carbon brushes
• Original opera ng manual
WWW.NIKOLAOUTOOLS.GR
BBS4010
230V/50hz
1200W
0.7 - 2.4 m/s
Μ42 1141 x 13 x 0.65mm - 10/14TPI
0 - 45° (120mm)
15Kg
2m
Led Light, Fast locking workpiece, Safety switch