BorMann PRO BBS4010 Mode D'emploi page 15

EN
ENVIRONMENTAL DISPOSAL
In order to avoid damages on transportation, the tool has to be delivered in solid packaging. Packaging as well as the unit and accessories are made of
recyclable materials and can be disposed accordingly. The tool's plastics components are marked according to their material, which makes it possible to remove
environmental friendly and differentiated because of available collection facilities.
This product must be handed over at the intended collection point. This can be done, for example, by returning it when purchasing a similar product or
delivering it to an authorised collection point for the recycling of old electrical and electronic devices. Improper handling of waste equipment may have
negative consequences for the environment and human health due to potentially hazardous substances that are often contained in electrical and electronic
equipment. By properly disposing of this product, you are also contributing to the effective use of natural resources.
Only for EU countries
Do not dispose of electric tools together with household waste material!
In observance of European Directive 2002/96/EC on waste electrical and electronic equipment and its implementation in accordance with
national law, electric tools that have reached the end of their life must be collected separately and returned to an environmentally compatible
recycling facility.
TROUBLESHOOTING
Problem
Motor does not work
The engine runs slowly and does
not reach the operating speed
Motor makes excessive noise
The motor does not reach its full
power
Motor overheats easily
Saw cut is rough or wavy
Workpiece pulls away / splinters
Burn marks on the piece when
working
Saw band jams when working
15
Possible Cause
Engine, cable or connector defective.
Fuses burnt.
Voltage too low.
Coils damaged.
Capacitor burnt.
Coils damaged.
Motor defective.
Network circuits overloaded (lamps, other motors,
etc.).
Overloading of the motor.
Insufficient cooling of the motor.
Saw band dull.
Tooth shape not appropriate for the material
thickness.
Excessive cutting pressure.
Saw band not suitable for use.
Saw band blunt.
Incorrect speed.
Saw band blunt.
Saw band resinous.
WWW.NIKOLAOUTOOLS.GR
Remedy
Have the machine checked by an authorised technician.
Danger! Never repair the engine yourself.
Check the fuses and replace them if necessary.
Have the voltage checked by your utility provider.
Have the engine checked by an authorised specialist.
Have the capacitor replaced by an authorised specialist.
Have the engine checked by an authorised specialist.
Do not use any other equipment or engines on the same circuit.
Avoid overloading the engine while cutting.
Remove dust from the engine in order to ensure optimal cooling
of the engine.
Sharpen the saw band.
Insert a suitable saw band.
Insert a suitable saw band.
Replace the saw band.
Choose a suitable speed for the workpiece to be cut.
Replace the saw band.
Clean the saw band.