Publicité
Les langues disponibles
Les langues disponibles
Installation
B
A
A—Cap
B—Plastic Insert (LP setting)
C—Spring Location
Type 1 Pressure Regulator
LP
Cap
Type 2 Pressure Regulator
All manuals and user guides at all-guides.com
Converting Type 1 Pressure Regulator for
Use with Natural Gas
1. Remove pressure regulator cap using a
2. Remove plastic insert from pressure regulator cap.
C
• Plastic insert fits tightly in cap.
3. Reverse plastic insert and carefully push plastic insert firmly into hole in
pressure regulator cap.
• Insert must show "NAT" or be blank.
4. Place pressure regulator cap on pressure regulator and tighten.
• Insert should not disturb spring in body of regulator.
Converting Type 2 Pressure Regulator for
Use with Natural Gas
1. Remove pressure regulator cap using
2. Reverse pressure regulator cap.
• Cap must show "NAT" or be blank.
3. Place pressure regulator cap on pressure regulator and tighten.
Converting Burners for Use with Natural Gas
1. Remove control knobs, grates, caps, and burner bowls.
2. Remove burners by removing burner screw with Phillips screwdriver.
Unplug burners from burner wires.
3. Lift maintop off burner box to expose air shutters.
4. Turn orifice hoods counterclockwise (open) approximately 1
5. Reassemble cooktop.
6. Adjust burner flame if necessary.
• See "Adjusting Surface Burner Flame" section.
5
8
5
/
" wrench.
8
/
" wrench.
8
1
/
to 2 turns.
2
Publicité
