GE GTH18DBRRCC Manuel D'utilisation Et D'installation page 20

REVERSING THE DOOR SWING
REMOVE THE FREEZER DOOR
1
Tape the door shut with masking tape.
Remove the hinge cover on top of the freezer door
(on some models).
Remove the two Torx ®
straight up to free the hinge pin from the socket in
the top of the door.
Top Hinge
Remove the tape and tilt the door away from the
cabinet. Lift it off the center hinge pin.
Set the door on a non-scratching surface with
the inside up.
Installation Instructions
screws, then lift the hinge
(CONT.)
REMOVE THE REFRIGERATOR
2
DOOR
Tape the door shut with masking tape.
Remove the center hinge pin with a 3/8" socket
and ratchet.
Plastic Washer
Hinge Pin
Center Hinge
Bracket
Remove the tape and tilt the door away from the
cabinet. Remove and save the washer on the hinge pin.
Lift the door straight up to free its bottom socket from
the pin in the bottom hinge bracket.
Set the door on a non-scratching surface with the
inside up.
CAUTION: Do not let door drop to the floor.
To do so could damage the door stop.
TRANSFER TOP HINGE TO
3
THE LEFT
Interchange hinge and screws at top right with screws
at the top left of cabinet.
Do not tighten screws on hinge side at this time.
20
Fresh Food Door