Zephyr ARC Serie Guide D'utilisation, D'entretien Et D'installation page 44

1. Determine blower position (examples on page 5).
Install each of the (2) mounting brackets to the sides of
the in-line blower housing using (4) M4x8 screws per
bracket. There are possible (4) mounting positions for
the brackets. FIG. A
to studs using (2) M4 x 1-1/2" screws per bracket.
2. Run 10" round ducting to inlet and outlet of in-line blower
housing. Secure with aluminum duct tape. Note: Cheng
and Arc Collection hoods require a 10" to 8" round
transition to be installed prior to the duct passing through
the ceiling. 8" round ducting is then connected to the hood.
A 10" to 8" transition is included with the blower. FIG. B
3. Run electrical conduit per local codes from junction
box on top of in-line
harness on top of the range hood. See instructions
included with range
4. Run (5) wires through conduit (black, white, blue, red
and green ground).
for style and gauge of wires. The ground wire shall
have a suitable gauge according to the Electrical Code
and Regulations. Connect wires to in-line blower and
blower wiring harness on hood per the diagram in FIG.
C. A cable lock (not supplied) might be required by local
codes. Check with local code requirements, purchase
and install appropriate connector if necessary. FIG. D
5. Turn circuit breaker on, power on hood and test all
functions. Check for leaks around duct connections.
!
CAUTION: At least two installers are required
due to the weight and size of the blower.
!
WARNING: Electrical wiring must be done by a qualified person(s) in
accordance with all applicable codes and standards. This range hood must be
properly grounded. Turn off electrical power at service entrance before wiring.
HOOD
wiring harness
All manuals and user guides at all-guides.com
Note: Brackets must be secured
blower to blower wiring
hood for more information.
Check local code compliance
White (common)
Black (high)
Blue (med)
Red (low)
Green (ground)
FIG. C
8
www.zephyronline.com
outlet
1
2
3
bracket positions
FIG. A
10" round
wood
ducting
stud
outlet
PBN-1000A
in-line blower
10" round
electrical
ducting
conduit
8" round
ducting
FIG. B
PBN-1000A
FIG. D
4
bracket
10" to 8"
transition
(if needed)
ceiling
Cable
Lock