cecotec Bolero CoolMarket Combi 322 White E Manuel D'instructions page 75

Note:
It is advisable to run the refrigerator uninterruptedly once you start using it.
Defrost
- This refrigerator includes an automatic defrost function, so there is no need to defrost it
manually.
Light bulb replacement
- The refrigerator has a LED light with low consumption and a long shelf life. In the event
of an anomaly, please contact the technical support service. Lights or other parts of the
appliance may only be replaced by the manufacturer.
Removing the shelves
Hold the shelves with both hands and push them upwards.
Hold one end of the shelf and lift it up while pulling it out. (Fig. 25)
7. TROUBLESHOOTING
For the following minor malfunctions, please try to solve the problem yourself before
contacting Cecotec Technical Support Service.
Fault
The
refrigerator
does not work.
Abnormal
noise.
Low cooling
efficiency.
Possible causes
The refrigerator is not connected to
the mains.
The circuit breakers or fuses are
damaged.
There is no power or the fuse trips.
The refrigerator is not stable.
The refrigerator is in contact with
the wall.
The food introduced is hot or there
is too much food.
You open the door too often.
The door gasket has objects that do
not allow to close it completely.
The refrigerator receives direct
sunlight or is close to a heat source.
The refrigerator is not well
ventilated.
The selected temperature is too
high.
BOLERO COOLMARKET COMBI 322 WHITE E / INOX E / DARK E
Possible solutions
Plug the refrigerator into the
mains.
Open the door and check the
light is on.
Set the adjustable feet of the
refrigerator.
Separate the refrigerator from
the wall.
Introduce food in the
refrigerator when it is at room
temperature.
Check and close the door.
Remove the refrigerator from
the heat source.
Keep the recommended
distances in the installation
section so the refrigerator is
well ventilated.
Set a suitable temperature.
ENGLISH
75