cecotec Bolero CoolMarket Combi 322 White E Manuel D'instructions page 66

ENGLISH
it may take more than 4 hours for food to cool down completely (try to open the refrigerator
door as rarely as possible).
If the refrigerator is installed in a wet place, be sure to check if the earthed cord and the
leakage breaker are working normally. If vibration noises occur due to contact of the
refrigerator with the wall or if the wall turns black due to air convection around the
compressor, remove the refrigerator from the wall. The installation of the refrigerator may
cause noise interference or image problems in mobile phones, landline phones, radio receivers,
or televisions near the device, so in this case, keep the refrigerator as far away from these
objects as possible.
Changing the opening direction of the door
If desired, you can change the direction in which the door opens, from the right side (by default)
to the left side.
Warning
- The refrigerator must not be connected to the power socket when you change the opening
direction of the door. Make sure to disconnect the plug from the power socket.
- Check figure 5 to check the tools you need.
- It is advisable to change the opening direction of the door between two people.
Fig. 5
A. Tools not supplied
1. 8-mm tube wrench
2. Flat-head screwdriver
3. Spatula
4. Crosshead screwdriver
5. Wrench
6. 8-mm wrench
B. Additional parts (included in the plastic bag)
1. Upper-left hinge
2. Upper-left hinge cover
3. Right-hand screw gap cover
4. Middle-left hinge
5. Left unblocker *2
6. Left doorstop *2
7. Allen key (4 mm)
Fig. 7
1. Self-tapping screw
2. Upper-right hinge cover
66