Levana Safe'N See LV-TW501-C Mode D'emploi page 9

All manuals and user guides at all-guides.com
CAMERA OPERATION
Switching the Camera ON/OFF
Position the camera to view the area you wish to
monitor, angle the camera lens for best view, by
turning it up or down.
1. Slide the power switch
2. The Power LED on the front of the camera will
light up green. The camera is now ready to
operate.
3. To turn OFF the camera, flip the power switch
back to the OFF position
Note: If you are using batteries to power the camera unit, and it does not start up
when the power switch is in the ON position, you may need to replace the
batteries. The Power LED will flash slowly when the batteries have low power.
Night Vision
The camera is equipped with eight IR (infrared) LEDs. These LEDs, located on the front of
the camera, allow you to see up to ten feet in complete darkness. Allowing you to check
your baby at any time of night.The night vision LEDs will activate automatically when the
camera detects that light levels are low.
Night Light
The camera has a calming night light included, you must use the parent unit (sold
separately) to turn on this night light. You will find detailed instructions on how to adjust
the settings of your baby monitor in the instruction manual included with the LV-TW501
system.
to the ON position.
9