Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
MOUNTING THE CAMERA
Placing the Baby Camera
This camera can be placed on a tabletop or hung from a screw on the wall
above the area being monitored. Place the monitor within ten feet of the area being
monitored for best picture, and to ensure that everything will be visible with the IR LEDs on.
Note: It is unsafe to mount the camera directly on the crib or anywhere within 3
feet of it. Power cords should NEVER be left within baby's reach.
To Mount on a Tabletop Safely:
1. Place the camera/monitor on a tabletop no less than 3
feet away from your baby's crib.
2. Feed the power cord down the back of the table or use
wall clips to secure the cord away so baby cannot reach.
3. Plug in the power cord, check to ensure that you are
getting a good view of your child and there are no
obstructions.
To Mount on a Wall Safely:
Before drilling a hole, it is important to check the reception and camera/monitor
positioning in the place that you intend on hanging it to the wall. Ensure you are hanging
the camera no less than 3 feet away from baby's crib.
1. Pre-drill a hole in the wall using a 3/16", 4.8mm
drill bit.
2. Insert a wall anchor into the wall and tap gently with
a hammer until the anchor is flush with the wall.
3. Insert a screw into the wall anchor and tighten until
the screw only sticks out about 1/2 inch.
4. Plug the power cord into the power jack of the
camera/monitor.
5. Locate the wall mounting hole on the bottom or back
of the camera/monitor.
6. Slide the hole over the screw sticking out of the wall.
7. Check to see that the camera/monitor is secure, if it is
loose you may have to tighten the screw more.
8. Use wall clips to secure the power cord away from the
crib or baby's reach.
7
Publicité
