Modular 70/40 GRACQE Serie Manuel D'installation, Emploi Et Entretien page 16

Possible causes:
- Insufficient gas supply pressure.
- Blocked tubing or nozzle.
- Defective gas tap or valve.
- Igniter defective or not properly connected.
- Igniter or igniter wire defective.
Pilot burner goes out during use.
Possible causes:
- Insufficient gas supply pressure.
- Defective gas tap or valve.
- Defective thermocouple or insufficient heating.
- Thermocouple incorrectly connected to gas tap or
valve.
- Knob of gas tap or valve not pressedsufficiently.
The main burner does not light (even though pilot is
lit).
Possible causes:
- Defective burner (gas outlet holes clogged).
ELECTRIC GRILL
The appliance does not heat.
Possible causes:
- Temperature thermostat defective.
- Heating elements defective.
Heating cannot be adjusted.
Possible causes:
- Temperature thermostat defective.
GAS LAVA STONE GRILL
The pilot burner does not light.
Possible causes:
- Insufficient gas supply pressure.
- Blocked tubing or nozzle.
- Defective gas tap or valve.
- Igniter defective or not properly connected.
- Igniter or igniter wire defective.
Pilot burner goes out during use.
Possible causes:
- Insufficient gas supply pressure.
- Defective gas tap or valve.
- Defective thermocouple or insufficient heating.
- Thermocouple incorrectly connected to gas tap or
valve.
All manuals and user guides at all-guides.com
16
- Knob of gas tap or valve not pressedsufficiently.
The main burner does not light (even though pilot is
lit).
Possible causes:
- Defective burner (gas outlet holes clogged).
REPLACING COMPONENTS
REMINDERS FOR REPLACING COMPONENTS
SHUT THE GAS SHUT-OFF VALVE
AND/OR SWITCH THE APPLIANCE OFF AT
THE MAIN SWITCH INSTALLED
UPSTREAM.
DISCONNECT THE APPLIANCE ELECTRIC
SUPPLY, IF PRESENT, BEFORE CARRYING
OUT ANY OPERATION.
AFTER REPLACING A GAS SYSTEM
COMPONENT, CHECK FOR GAS LEAKS AT
CONNECTION POINTS.
AFTER REPLACING AN ELECTRICAL
SYSTEM COMPONENT, CHECK IT IS
CORRECTLY WIRED.
GAS GRILL
REPLACING THE GAS TAP.
- Remove the control knob.
- Remove the bottom front panel.
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.
REPLACING THE BURNER, THE PILOT BURNER AND
THE THERMOCOUPLE.
- Remove the grease collection drawer.
- Remove the control panel.
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.
REPLACING THE MAIN BURNER.
- Remove the grease collection drawer.
- Remove the control knob.
- Remove the bottom front panel.
- Remove the control panel.
- Remove the splashguard, the grilles, the tiles, the
front tile support and the burner guard.