Eaton iLumin Plus ILS-0010 Guide D'installation Rapide page 8

Connecting to the building LAN or VLAN
Medium and large iLumin Plus panels may include the EG2
optional ethernet connection device. The EG2 acts as a host
for the iLumin series of remote applications including iOS
(iPhone/iPad
& Android OS devices). Coupling the EG2 to a Wi-Fi network
enables secure scene control, visual feedback and
modification from your hand held device. Once configured,
the EG2 automatically loads room and scene information
to the connected hand held device.
In addition to its handheld device capability, the EG2
houses internal webserver pages that allow for basic
scene control functions. These internal pages are
accessed through an internet browser and are password
protected for security.
The EG2 also facilitates the commissioning of the iLumin
Plus system, allowing our factory trained technicians
to use the EG2 connection to configure the iLumin Plus
system using iCANsoft on a LAN or Wi-Fi enabled PC or
via the internet rather than by connecting directly into the
iLumin Plus network.
• Factory default IP settings:
• IP Address: 192.168.0.100
• Mask: 255.255.255.0
• Gateway: 192.168.0.1
• DHCP: OFF
Note: The EG2 default settings are to use a
fixed IP address of 192.168.0.100. Any device
used to communicate with the EG2 will need to
be located within the 192.168.0.x subnet unless
IP address settings are changed.
Use the iCANsoft suite software package for
the configuration process.
Ethernet Connection
Wiring Information:
Connection: RJ45 connector
Connect:
network access.
*Note: The EG2 can be used to access the lighting network
via the buildign LAN or VLAN.
*Note: The EG2 can be use as a LAN bridge to connect
different building lighting networks as a single lighting network
over the building LAN or VLAN. See EG2 Bridge application
note for more information.
All manuals and user guides at all-guides.com
iLumin
Touchscreen
Occupancy Sensor
DALI bus (polarity, topology free)
Dual Tech
occupancy
sensor
0-10V LED
Powerpack
controller
LED Luminaire
with 0-10V driver
Use Category 5 or Category 6 cable minimum
Connect to building LAN or VLAN for lighting
Eaton
1121 Highway 74 South
Peachtree City, GA 30269
www.Eaton.com/lightingsystems
For service or technical assistance:
1-800-553-3879
Sample iLumin Plus network systems
Below are some examples of a simple iLumin Plus network
and a complex iLumin Plus network application.
Simplified
SCMD4
0-10V LED
controller
SCMD4
iLumin Plus panel
ILS-0020
8 DALI buses
Complete
DMX Fixture
Curtain Blind
Control Control
Reverse phase track lighting
DMX Fixture
SCD96 RI-2
DMX Out Relay Out
LDCM
(0-10V to Reverse
Phase Module)
ILM-2110
Medium Panel
24 Relays, 12 0-10V, 4 DALI bus
SI-2
AV & Partitoning
Circuit Breaker Panel
iCANet (Daisy chain CANBUS network using Belden 1502 or 1502P cable)
Occupancy/
LED Luminaire Wallstation
Daylight Sensor
with DALI driver
Relay pack for
LED or plug load
Warranties and Limitation of Liability
Please refer to www.eaton.com/LightingWarrantyTerms
for our terms and conditions.
Garanties et limitation de responsabilité
Veuillez consulter le site www.eaton.com/
LightingWarrantyTerms pour obtenir les conditions
générales.
Garantías y Limitación de Responsabilidad
Visite www.eaton.com/LightingWarrantyTerms para
conocer nuestros términos y condiciones.
Canada Sales
5925 McLaughlin Road
Mississauga, Ontario L5R 1B8
P: 905-501-3000
F: 905-501-3172
© 2018 Eaton
All Rights Reserved
Printed in USA
Publication No. IB503023EN
August 8, 2018
2 wire controls wiring (polarity, topology free)
wallstation occupancy/ LED luminaire with DALI driver
daylight Sensor
powerpack
0-10V LED luminaire
dual technology
occupancy sensor
Flacility Manager BMS Pro
ICANSoft Suite
Software
Building LAN or VLAN
ILL-3301
Large Panel
36 Relays, 36 0-10V, EG2 inside
Building WLAN
36 Relays
and
0-10V zones
24 Relays
and 12
0-10V zones
Circuit Breaker Panel
Circuit Breaker Panel
TC1
Network timeclock
2 wire control wiring (polarity, topology free)
Occupancy/
Daylight Sensor
2 wire control wiring (polarity, topology free)
Eaton is a registered trademark.
All trademarks are property
of their respective owners.
Procuct availability, specifications, and
compliances are subject to change
without notice.
relay pack for
LED or plug load
BACnet
Building
Management
System
iLumin
APP
ILS-0020
Small Panel
0 Relays, 0-10V, 8 DALI bus
8 DALI buses
Wallstation
Wallstation