Publicité
Les langues disponibles
Les langues disponibles
3 hours. Refer to the chapter 'Setting and
starting a washing programme'.
Use of the appliance
Refer to the following instructions for each
step of procedure:
1. Make a check if the water softener level
is correct for the water hardness in your
area. If necessary set the water softener.
2. Fill the salt container with dishwasher salt.
3. Fill the rinse aid dispenser with rinse aid.
4. Load cutlery and dishes into the dish-
washer.
Setting the water softener
The water softener removes minerals and
salts from the water supply. Minerals and
salts can have bad effect on the operation of
the appliance.
Water hardness is measured in equivalent
scales:
• German degrees (dH°).
Water hardness
°dH
°TH
51 - 70
91 - 125
43 - 50
76 - 90
37 - 42
65 - 75
29 - 36
51 - 64
23 - 28
40 - 50
19 - 22
33 - 39
15 - 18
26 - 32
11 - 14
19 - 25
4 - 10
7 - 18
< 4
< 7
1) No use of salt required.
You must set the water softener man-
ually and electronically.
Manual adjustment
The appliance is set at the factory at po-
sition 2.
1. Open the door.
2. Remove the lower basket.
3. Turn the water hardness dial to position
1 or 2 (refer to the chart).
All manuals and user guides at all-guides.com
5. Set the correct washing programme for
6. Fill the detergent dispenser with the cor-
7. Start the washing programme.
• French degrees (°TH).
• mmol/l (millimol per litre - international unit
• Clarke.
Adjust the water softener to the water hard-
ness in your area. If necessary, contact your
local water authority.
mmol/l
Clarke
9,1 - 12,5
64 - 88
7,6 - 9,0
53 - 63
6,5 - 7,5
46 - 52
5,1 - 6,4
36 - 45
4,0 - 5,0
28 - 35
3,3 - 3,9
23 - 27
2,6 - 3,2
18 - 22
1,9 - 2,5
13 - 17
0,7 - 1,8
5 - 12
< 0,7
< 5
4. Install the lower basket.
the type of load and soil.
rect quantity of detergent.
If you use detergent tablets, refer to the
chapter 'Use of detergent'.
for the hardness of water).
Water hardness setting
manually
2
2
2
2
2
2
1
1
1
1)
1
electrolux 23
electronically
10
9
8
7
6
5
4
3
2
1)
1
Publicité
