Publicité
Les langues disponibles
Les langues disponibles
3b.
If installing after the cooktop
is placed into cutout:
• Place the cooktop upside down on a
protective surface (blanket, pad).
burner box
Glass cooktops only:
Remove foam strip from literature
package. Apply foam strip around bottom
of cooktop flush with edge. Turn cooktop
right side up.
• Carefully place cooktop into cutout.
IMPORTANT: Check that the front edge of
the cooktop is parallel to the front edge
of the countertop.
Lift entire cooktop up from cutout when
repositioning cooktop to prevent
scratching the countertop.
• Remove the attachment screws from
selected bracket locations on the
bottom of the burner box.
• Attach brackets as shown so that they
are beyond edge of burner box and the
clamp screws (see Step 4) will contact
the countertop bottom. Tighten screws
securely.
cooktop
countertop
burner
box
bracket
attachment screw
4.
Place the 2-1/2" (6.4 cm) clamping
screws into the brackets. Use a
screwdriver to tighten the screws against
the countertop. Do not overtighten.
6
All manuals and user guides at all-guides.com
access cap
foam
strip
5.
Install the pressure regulator with
the arrow on the regulator pointing up
toward unit and in a position where you
can reach the access cap.
IMPORTANT: All connections must be
wrench-tightened. Do not make
connections to the gas regulator too
tight. Making the connection too tight
may crack the regulator and cause a gas
leak. Do not allow the regulator to turn
on the pipe when tightening fittings.
adapter
nipple
manual shutoff
valve
6.
Assemble flexible metal connector
from the gas supply pipe to the pressure
2-1/2" (6.4 cm)
clamping
regulator. You will need to determine the
screw
fittings required, depending on the size
of your gas supply line, flexible metal
connector and shutoff valve.
7.
Use pipe-joint compound made for
use with NATURAL and L.P . gas. If
flexible metal connector is used, be
certain tubing is not kinked.
rear of
cooktop
pressure
regulator
gas-flow
arrow
pointing up
flexible metal
3/8"
connector
nipple
3/8" adapter
use pipe-joint
pressure
compound
regulator
All connections must be
wrench-tightened.
shutoff valve
"open" position
to cooktop
8.
Open shutoff valve in the gas
supply line. Wait a few minutes for gas to
move through the gas line.
9.
Leak testing of the appliance shall
be conducted according to the following
instructions:
Test all connections by brushing on an
approved non-corrosive leak-detection
solution. Bubbles will show a leak.
Correct any leak found.
10.
Plug into a grounded
3-prong outlet.
ignitor
electrode
gas tube
opening
11.
Put burner caps on each burner
base. Place burner grates over burner
bases and caps.
gas supply
line
burner cap
burner
base
Publicité
