CEBEK R-50 Mode D'emploi page 4

R-50
Programming time for night fall ramp activation
The NOCHE Led must light on, with push buttons 1Hora 10 MIN 1 Min you have to select the time for night fall ramp activation,
each time you press, the module will increase one unit, the led will indicate it with a sparkle.
Example: time for daybreak ramp activation 20 hours, 18 minutes:
Press 20 times 1 HORA, then 1 times 10 minutes, then 8 times 1 MIN
Once programmed the hour of the beginning of the ninght fall ramp, press RAMPA, the NOCHE Led lights off, and RAMPA led will
lights on.
Programming of the daybreak daybreak/night fall Ramp
NOTE: The time of daybreak/night fall ramps is the same one, the RAMPA led must light on, with the buttons 1Hora 10 MIN 1 Min,
select time of the ramp, each time you press, the module will increase one unit and the led will indicate it with a sparkle.
Example: RAMPA 25 minutes, press 2 times 10 MIN, then 5 times 1 MIN.
Once programmed RAMPA, you can leave the programming mode.
To leave the programming mode
Press PROG during 5 seconds to leave the programming mode, led PROG will lights off.
DIA or NOCHE Leds will intermittently light on according to the programming.
The R 50 is ready to be used.
R50 Test Function
It allows to check the present hour, the hour of the daybreak ramp activation, the hour of the twilight ramp activation and the
duration of the daybreak/twilight ramp.
To be in test mode, press TEST during 5 seconds until the TEST led lights on.
To Check the present hour: Press HORA
Example: if in this moment the hour is 8:32, it will turn on 8 times the 1 HORA, then 3 times 10 MIN, and 2 times 1 MIN.
To check the hour of ramp daybreak ramp activation: Press DIA
Example: If you programmed an activation at 7:25, it will turn on 7 times the 1 HORA, then 2 times 10 MIN, and 5 times 1 MIN
To check the hour of ramp twilight ramp activation: Press NOCHE
Example: If you programmed an activation at 19:30, it will turn on 19 times the 1 HORA, then 3 times 10 MIN.
To check the hour of daybreak/twilight ramp activation: Press RAMPA
Example: If you programmed a ramp of 25 min, the led 10 MIN will lights on 2 times and the Leds 1 MIN, lights on 5 times.
To leave the Test mode
Press Test button during 5 seconds to leave the test mode, the Test led will lights off, DIA and NOCHE leds will intermittently lights
on according to the established program.
www.cebek.com - sat@cebek.com
4