Overview Of The Components / Scope Of Delivery; Using The Appliance - Clatronic BS 1308 Mode D'emploi

• Do not use the appliance in damp rooms!
• Never use without the filter. Check that the filter is inserted correctly!
• Keep hair, clothing and body parts away from the vacuum nozzle
during use!
• Keep the vacuum cleaner away from sources of heat like radiators,
ovens, etc.!
Overview of the Components /
Scope of Delivery
1 Suction hose
2 Telescopic suction tube
3 Connection head of the suction hose
4 Hose connection
5 Dust collector with filter insert
6 Carrying handle
7 Release button for dust collector
8 Cable-winding button
9 On / off switch
10 Lever for opening the ventilation grille (with output filter)
11 Parking aid
12 Dust collector base plate
13 Lever for extending and retracting the brushes
14 Floor nozzle (with hook (not shown))
Accessories not shown:
Groove and brush nozzle
Start-up
• Insert the connection head of the suction hose into the
hose connection of the appliance. Tighten the connection
header anticlockwise.
• To release the hose again, turn the connecting header
clockwise.
• Insert the suction tube into the handle if required.
• You can use the sliding switch on the telescopic suction
tube to adjust the length individually.
• Assemble the floor nozzle and / or the accessories.
Nozzle Attachment
Floor nozzle (14)
The floor nozzle is fitted with rollers for easier guiding.
You can clean smooth surfaces and carpets with the floor
nozzle.
• Adjust the brushes outwards or inwards using the lever
(13)
BS1308_IM
Best use of the appliance depends on the texture of the floor
covering. We recommend the following use:
• Use without brushes:
For vacuuming floor coverings with a deep pile
• Use with brushes:
For vacuuming smooth floors and carpets with a shallow
pile
Groove and brush nozzle
For vacuuming upholstery, curtains and in corners and
crevices etc.
NOTE: "2-in-1" nozzle:
When this is folded together it can be used as a groove
nozzle. If you would like to use the brush nozzle, pull the
brush section in the direction of the arrow until it locks in
place.
To detach the nozzle attachments from the suction pipe, pull
them off by turning them slightly.

Using the Appliance

1. Unwind the length of cable you require.
CAUTION:
• Pull out the cable up to the maximum length indi-
cated with the yellow mark.
• Never pull the cable out up to the red mark as the
cable winding can be damaged.
NOTE:
If the red mark is visible, pull in the cable with the help
of the cable winding button back to the yellow mark.
2. Insert the mains plug into a correctly installed power
socket.
3. Turn the appliance on by the on / off switch by pressing
down the button.
4. Set the "carpet / hard floor" switch, depending on the floor
covering.
5. Vacuum at a steady speed. There is no need to exert
pressure.
NOTE:
Pay attention to the range that can be covered with the
cable length!
31
01.08.17