i-box Rest Manuel D'instructions page 8

If problems occur when charging or charging doesn't start:
• Adjust the phone position continuously until the wireless charging LED lights up.
• If your Rest table speaker is in battery mode (disconnected from the mains) make
sure it is switched on to enable wireless charging.
• Remove your smartphone from its case if the thickness of the case exceeds 5mm
or if it has a metal composition.
• The built-in wireless charge receiver may not be located centrally inside the
phone, place the phone slightly off centre from the cross.
• Charging time varies depending on the battery's capacity and its residual charge.
• The components may heat up during the charging process. They will slowly cool
down after charging.
Power Saving
Power Saving: If there is no Bluetooth audio input for 10 minutes your Rest table
speaker will automatically power off
USB Charging
For mobiles and other devices that don't have wireless charging capability a 5V��1Amp
USB charging port (5) is provided on the back panel of your table speaker. When the
speaker is either switched on, or connected to mains power, the USB port will be
active and ready to charge. Use your mobile's standard charging cable to connect to
the USB charging port.
Specifications
Power supply output
Power adaptor input
Audio output
Bluetooth version
Bluetooth range
Battery
Charging time
Playtime
Wireless charging
USB charging
Dimensions:
www.iboxstyle.com
even if wireless charging is being used.
9V��3.5A
100-240V~50/60Hz, 1A Max
Total: 20W, 2x 5W(Mid/Hi) + 1x 10W (Woofer)
5.0, A2DP, AVRCP
≤ 10m
Lithium 7.4V. 2600mAh
4 hours
Up to 4 hours
5W
1A
400 x 560 x 400mm (L x H x D)
Rest | 08