When you successfully pair your speaker and device, you will hear a chime and
the blue LED (or steady red with flashing purple) will stop flashing and will remain
constantly lit.
To pair to a different Bluetooth device long press the
you will hear a chime and the Blue LED will start flashing to indicate that your speaker
has disconnected and re-entered pairing mode.
Bluetooth Audio Playback
You can use your Bluetooth device to control music playback. Alternatively the
buttons on the control panel of the Rest can be used to play/pause
and navigate between tracks
can use the controls on your Bluetooth device or on the speaker control panel (short
press
-/+
buttons 3 & 4) .
AUX IN Mode
An AUX IN port (8) is provided for connection to non-Bluetooth devices.
1. Connect a compatible audio device using a 3.5mm stereo jack cable (not supplied)
connected to the AUX IN socket (8) on the back of the Rest.
Short press the
The LED (7) will flash blue slowly (every second) when the speaker is in AUX mode.
2. Ensure the connected device is producing an audio signal, then adjust the volume
using a combination of the audio source volume controls and the
buttons on the speaker control panel. To control playback use the controls on your
AUX device
To return to Bluetooth mode short press the
Wireless Charging
The Rest table speaker features a unique wireless
charging zone located as shown opposite.
Place any Qi wireless charging enabled mobile device
directly onto this zone when the speaker is switched on
(or on charge), your device will begin charging and the
Wireless Charging LED (6) will light up Green.
Please Note:
The Wireless Charging LED (6) will flash Green if metallic objects other than Qi
enabled devices are placed in the charging area. Please remove them from the
charging area immediately as they can represent a hazard and could cause a fire.
07 | Rest
/
(long press 3 & 4). To control the volume you
Power/Mode button (1) to enter AUX mode.
Play/Pause button (2)
Power/Mode button (1).
(short press 2)
/
(3 & 4)