CASO DESIGN AirFry Chef 1700 Mode D'emploi Original page 41

17.1 Safety notices
Attention
► Only qualified electricians, who have been trained by the manufacturer, may carry out any
repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the user and damages
to the device.
17.2 Causes and rectification of faults
The following table assists in localizing and rectifying minor faults.
Problem
The device is not functioning
The process doesn't start when
start / stop is pressed.
E1 / E2 is shown in the display.
E3 is shown in the display.
► If you are unable to solve the problem with the steps shown above, please contact
Customer Service.
18 Disposal of the Old Device
Old electric and electronic devices frequently still contain valuable materials.
However, they also contain damaging substances, which were necessary for
their functionality and safety. If these were put in the non-recyclable waste or were handled
incorrectly, they could be detrimental to human health and the environment.
Therefore, do not put your old device into the non-recyclable waste under any
circumstances.
Utilise the collection point, established in your town, to return and recycle old electric and
►
electronic devices. If necessary, contact your town hall, local refuse collection service or
your dealer for information.
Ensure that your old device is stored safely away from children until it is taken away.
►
19 Guarantee
We provide a 24-month guarantee for defects caused by production or material faults,
beginning on the date of purchase. Our guarantee is valid for Germany, Austria and the
Netherlands. For all other countries, please contact us.
Your legal guarantee claims as per Art. 437 ff. German Civil Code (BGB) will remain
unaffected by this. You may exercise your statutory guarantee rights free of charge. The
Solution
Please check whether the power plug is properly plugged.
Make sure the door is properly locked.
The temperature sensor in the device is defective.
Contact customer service.
The temperature in the device is too high. Please stop the
process until the device has cooled down and then start
again.
Please note
Please note
41