Craftsman CMXELAYMPL1029 Guide D'utilisation page 5

• Make sure cord is located so that it will not be stepped
on, tripped over, or otherwise subjected to damage or
stress.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to ratio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause interference in other
devices, the user is encouraged to try to correct the interference
by one or more of the following methods:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the
receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician
for help.
NOTICE: Per FCC Part 15, changes or modifications to this
equipment not expressly approved by CRAFTSMAN could void
your authority to operate this equipment.
This Class B digital apparatus complies with Canadian ICES-
003.
SAVE THESE INSTRUCTIONS
FOR FUTURE USE
Refer to Figure A at the beginning of this manual for a
complete list of components.
Intended Use
This work light is suitable for Indoor/Outdoor Use. The work
light has wet locations rating, can be used outdoor in rain or
wet conditions.
DO NOT use in presence of flammable liquids or gases.
DO NOT let children come into contact with the work light.
Supervision is required when inexperienced operators use
this work light.
Specifications
Model
Power
Brightness
Color Temperature
Color Rendering Index
Input Voltage
Location Rating
Power Cord
Net Weight
CMXELAYMPL1029
92 Watts
9,000 Lumens
4000K
80
AC 120V 60Hz
Wet Locations
5 ft
12.79 Lbs.
UNPACKING

WARNING: It is unlikely the product is faulty or has
a missing component. If you find product is faulty, do
not use the product until the parts have been replaced
or the fault has been rectified. Failure to do so could
result in serious injury.
Remove work light from carton and discard all packaging.
ASSEMBLY AND ADJUSTMENTS

WARNING: To reduce the risk of serious personal
injury, turn unit off, disconnect it from power
source and put it on a stable secure position
before making any adjustments or removing/
installing attachments or accessories.

WARNING: Risk of unsafe operation. When
performing maintenance, you may be exposed to
voltage sources. Personal injuries can occur. Before
performing any maintenance, disconnect power
source from the work light.
The work light is fully assembled out of the box.
KNOW YOUR PRODUCT
READ THIS USER MANUAL AND ASSOCIATED SAFETY
WARNINGS BEFORE ASSEMBLING AND ADJUSTING THIS
PRODUCT. Compare the illustrations with the actual unit
to become familiar with the location of knobs, switches,
components and adjustment features. Save this manual for
future reference.
Tripod Set Up (Fig. B, C)
To set up the tripod from its Collapsed Carrying Position
hold Tripod Head securely while pushing the Support
4
Legs Collar Assembly 14 downward until it reaches the
Support Legs Collar Assembly Position Lock
the lower end of the tripod stand. Keep pushing until it
clicks into place. This indicates that the Support Leg Collar
Assembly is locked in place.
Fig B
4
English
21
located at
16
14
16
,
3