KEUCO iLook move 17612 01 9003 Instructions De Montage Et Mode D'emploi page 3

EN
Important information – please read!
Key to symbols
Warning - risk of electric shock
Warning - risk of water damage
Note, tip or reference
Correct installation
Incorrect installation
On/Off switch
General information
– The function, safety and integrity of the product are only
guaranteed if the instructions given in this manual are
adhered to. Non-observance of the safety instructions
could lead to bodily injury and damage to property.
The manufacturer is not liable for damage resulting from
non-observance of the instructions.
– To avoid installation errors and damage to the product,
it is essential that the installation instructions are followed
carefully.
– Besides the information given in this manual, please follow
the relevant general safety and accident prevention
regulations.
– This product left our factory in a condition complying with
all the requirements of technical safety.
– The installation of our product should only by carried out
by an approved domestic installer in compliance with
VDE 0100 Part 0701.
– The product must be connected to the power supply
only with the in-wall mains adapter supplied by the
manufacturer with this product.
– Before commencing any cabling work, check that the
cables are at zero voltage. Measures must be taken to
ensure that the cables remain dead for the duration of the
work (e.g. prevent the power supply from being switched
back on).
– The attached documents shall be handed to the user
after installation and functional test.
– Due to its long service life, replacement of the lamp is not
provided for.
– Faulty cords may only be replaced by the manufacturer.
– Before carrying out any drilling work, ensure that no
plumbing or wiring is routed behind the place where you
intend to drill.
– If the mirror is exposed to direct sunlight, there is a risk
of fire occurring due to the mirror focusing the sunlight in
the same way as a magnifying glass. When installing the
mirror, choose a position and angle which do not allow
direct sunlight to fall on the mirror.
– All dimensions are given in millimetres (mm).
– Technical changes reserved.
Please refer to the attached care and the warranty
card for information on warranty and care.
Technical data
Magnification:
Supply voltage:
Standby power:
Light colour:
Lamp:
- Type round (17612 01 9003)
- Type square (17613 01 9003)
Energy efficiency class:
– Round model (17612 01 9003)
– Rectangular model (17613 01 9003)
Operation
– Switching through the house installation.
– Separate switch necessary.
Installation
– To connect up the cables and the in-wall mains adapter
the basic construction set 17699000003 (hollow wall) or
17699000004 (masonry) is required.
3 - 14
x 5
220-240 V AC, 50-60 Hz
0 Watt
6,500 kelvin
LED, maintenance-free
1 x 4.5 Watt
1 x 7 Watt
A, 5kWh/1,000h
A, 8kWh/1,000h