Wine Cellar Use; Normal Sounds; Using The Controls - Jenn-Air JUW24FRERS Guide D'utilisation Et D'entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Normal Sounds

Your new wine cellar may make sounds that your old one didn't
make. Because the sounds are new to you, you might be
concerned about them. Most of the new sounds are normal. Hard
surfaces, such as the flooring and surrounding structures, can
make the sounds seem louder. The following describes the kinds
of sounds and what may be making them.
Your wine cellar is designed to run more efficiently to keep
your wine at the desired temperatures and to minimize energy
usage. The high efficiency compressor and fans may cause
your wine cellar to run longer than your old one. You may also
hear a pulsating or high-pitched sound from the compressor
or fans adjusting to optimize performance.
Rattling noises may come from the flow of refrigerant or items
stored inside the wine cellar.
As each cycle ends, you may hear a gurgling sound due to
the refrigerant flowing in your wine cellar.
You may hear water running into the drain pan when the wine
cellar is defrosting.
You may hear clicking sounds when the wine cellar starts or
stops running.

Using the Controls

The control panel is located at the top of the compartment and
facing front. The control of the wine cellar has no mechanical
parts or buttons. When disconnected, the control panel displays
nothing and may be difficult to locate.
Turning Control On/Off
The first time that the wine cellar is plugged in, the control will
be in Cool Off mode. Cool On and Cool Off will be the only
options that display.
Press COOL ON for 3 seconds to turn on the wine cellar. All
menus and recommended temperature settings will be
displayed.

WINE CELLAR USE

.
The left temperature and preset touch pads control the
temperature of the upper compartment.
The right temperature and preset touch pads control the
temperature of the lower compartment.
Viewing Celsius Temperatures
Press the F/C touch pad to toggle between displaying the
temperature in degrees Fahrenheit and degrees Celsius. The
corresponding indicator will illuminate.
Adjusting the Control
When the wine cellar is turned On for the first time, the
temperature defaults to the recommended setting. There are two
adjustable temperature controls, one for each compartment.
To adjust set point temperatures, press "+" (plus) or "-"
(minus) until the desired temperature setting is reached.
NOTE: The set point for the wine cellar is 50°F (10°C) for both the
upper and lower compartments. The set point range for the
upper compartment is 42°F to 54°F (5°C to 12°C) and 42°F to
64°F (5°C to 17°C) for the lower compartment
The control is set correctly when the wine is as cold as you like it.
NOTE: Wait at least 24 hours between adjustments for the
product to acclimate. Recheck the temperatures before making
further adjustments.
Using Presets
For your convenience, your wine cellar also has controls that are
preset to recommended storage temperature for specific wines.
Pressing any preset option will set the temperature to the
recommended temperature for the specified wine:
Assorted: 54°F (12°C)
Champagne: 46° (7°C)
Red Wine: 64°F (17°C)
Sweet Wine: 42°F (5°C)
White Wine: 50°F (10°C)
A
A. F/C touch pad
7 7 7

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Juw24flersJub24flecxJub24frecx

Table des Matières