Lenze E82ZBU Mode D'emploi page 8

All manuals and user guides at all-guides.com
Setpoint selection through potentiometer and reversal of direction of rotation (CCW
- stop - CW) through switch
Description of the functionality
• Deceleration after STOP along the quick stop ramp (C0105).
• Deceleration and acceleration after a reversal of the direction of rotation along
ramps C0013 and C0012.
For this, the following is required:
1. Connect the switch/potentiometer unit to the Standard-I/O.
2. Configure hardware and software of the motec for a setpoint range of 0 ... 5 V:
- Adapt the switch position at the function module.
- Adapt C0034.
3. Configure two digital inputs with the signals CW/QSP and CCW/QSP
Example for terminal configuration C0007 = -16-
STANDARD
ON
1 2 3 4 5
62 7 8 9 7 20 28 E1 E2 E3 E4
Terminal assignment
Switch position Switch position
Parameter setting
Wiring with Standard-I/O
S
X3
62
min
€
39 A1 59
ó Switch/potentiometer unit
Wire bridges
Wiring for setpoint selection through potentiometer
Wiring for reversal of direction of rotation through
switch
CW CW rotation
CCW CCW rotation
Setpoint selection
X3/8: White wire
X3/9: Green wire
X3/7: Brown wire
1 2 3
OFF OFF ON
C0034 = -0-
>100k
GND1
+5V
7 8 9 7 20 28 E1 E2 E3 E4 39 A1 59
‚
10k
max
Change of direction of rotation
X3/20: Yellow wire
X3/E3: Pink wire = CW rotation
X3/E4: Grey wire = CCW rotation
4 5
OFF OFF
- 3 -
‚
1 = CW 0 2 = CCW
0
1 2
DC supply + 20 V
Wire bridge to X3/28
"Controller inhibit" (CINH)
(CW/QSP on X3/E3)
(CCW/QSP on X3/E4)
C0007 = -16-
MA82ZBU 1.0
