Lenze E82ZBU Mode D'emploi page 6

All manuals and user guides at all-guides.com
EDK82ZBU
00415671
06/00
These Instructions
• describe the installation and handling of the switch/potentiometer unit.
• are only valid
- for switch/potentiometer units with the nameplate data E82ZBU
- together with the Operating Instructions of the corresponding controller.
Description
The switch/potentiometer unit E82ZBU enables
• the selection of an analog setpoint signal for Lenze controllers through the function
modules Standard-I/O and Application-I/O.
• easy control of Lenze controllers through digital inputs of the function modules
Standard-I/O and Application-I/O (e. g. reversal of direction of rotation).
Range of application
To be used with 8200 motec frequency inverters as of nameplate label
E82MVxxx_4Bxxx 0x0x
Items supplied
General data and application conditions
Type of protection
Dimensions (W x H x D)
Possible mounting positions Mounting to the heatsink of a
Switch/potentiometer unit E82ZBU
for 8200 motec
1 switch/potentiometer unit with pre-cut 2.5 m connection cable
1 mounting sheet 60 mm x 60 mm
4 screws M4 x 30 for mounting the switch/potentiometer unit to the
mounting sheet
2 screws M4 x 20 with spring steel sheet for mounting to the
heatsink of the motec
IP65
approx. 65 mm x 115 mm x 85 mm
motec
(
Lenze GmbH & Co KG, Postfach 10 13 52, D-31763 Hameln
(+ 49) 5154 82-0, Fax Service: (+ 49) 5154 82-1112
Mounting to a wall
MA82ZBU 1.0