Publicité
Les langues disponibles
Les langues disponibles
CS.VTR.IST-1 / Rev 1.2
Display
The remote control display shows information concerning the operating status of the appliance.
The display is activated by pressing key 3 (On/Off).
The figure below shows the display when the appliance is in normal operating mode.
Operating status
After turning on the menu using key 4 (Set), it is possible to choose from many types of display and available settings according to the selected menu.
The following diagram shows the display when navigating the menu.
THE MENU
Access the Menu by pressing key 4 (Set) on the remote control.
The menu is divided into different items and levels, providing access to the programming and settings options of the appliance.
Keys 1 and 2 (Increase and Decrease) allow you to select the menus to be modified.
Key 4 (Set) accesses the menu to be modified, storing the changes made previously.
Key 5 (Esc) returns you to the previous menu item, storing the changes made previously.
Inside the menu to be modified, use keys 1 and 2 (Increase and Decrease) to modify the value set in the selected menu.
Listed below are the menus present on the PCB, with the relevant explanations.
MENU 01 – STAND-BY
If disabled, the switching off of the appliance once the "SET ROOM" temperature setting has been reached is excluded. The operating power will however
be modulated; the display will show the word "MODULATION"
If enabled the appliance will enter modulation mode and/or switch off if the temperature set in "SET ROOM" is reached. During the modulation stage the
display will show the words "OK ST-BY"; when switched off it will show "STAND-BY".
Clock
13
ENGLISH
Room temperature
Power setting in POWER SET
Publicité
