Sanyo LCD-42E40W Mode D'emploi page 29

Output terminals
Digital Audio Output Audio Output
1
CONFIGURATIONS OF VGA TERMINALS
VGA IN (D-SUB) TERMINAL
Terminal : D-SUB15 PIN
Connect video output terminal of LCD TV to this terminal with a VGA Cable (not supplied). When connecting
Macintosh computer, the MAC Adapter (not supplied) is required.
This LCD TV can correspond to the signals below. After connecting with the computer, the TV can automatically
recognize the signal from the connected PC (computer) / HDMI.
PC SIGNAL MODE COLUMN (recommended)®
SYSTEM MODE Resolution
VGA
SVGA
XGA 1024x768
WXGA 1360x768
WXGA 1280x768
SXGA 1280x1024
NOTE:
In principle, the TV can not display signal modes not described in the above column. However, it can sometimes
display a signal very similar with one of the modes described.
It is not the trouble of the TV if interference appears on the picture while switching the signal mode.
The Dot Clock of the computer's signal must be less than 108 MHz.
When the input signal from PC is out of the PC signal mode column, above, "No Support" caution message will
display. But in some case, the LCD TV will still display the PC signal though the signal mode doesn't exist on the
list above. Under this condition, the display position may not correct and the quality may not be admitted also.
When input signal is digital from HDMI terminal, refer to the chart below.
SYSTEM MODE Resolution
480I 720(1440)x480
480P
720P/60 1280x720
1080I/60 1920x1080
1080P/24 1920x1080
1080P/60 1920x1080
All manuals and user guides at all-guides.com
1
1
2
3
4
5
6
7
8
PC / HDMI SIGNAL MODES
V-Freq.(Hz)
640x480 59.94
800x600 60
60
60
60
60
V-Freq.(Hz)
59.94
720x480 59.94
60
60
24
60
Red Input 9
Green Input 10
Blue Input 11
Reserved 12
Reserved 13
GND 14
GND 15
GND
H-Freq.(KHz) PIXELS CLOCK (MHz)
31.47
37.88
48.36
47.712
47.78
63.981
H-Freq.(KHz) PIXELS CLOCK (MHz)
15.73
31.47
45
33.75
27
67.5
+5V
NC
Sense 0
DDC_SDA
Horiz. sync.
Vert. sync.
DDC_SCL
25.18
40
65
85.5
79.5
108
27
27
74.25
74.25
74.25
148.5
29