All manuals and user guides at all-guides.com
To utilise the Enigma Camera database you will need to register your Syrius and
perform a download. Please refer to 'Registering your Syrius' , 'System Requirements
and Software Installation' later in this Quick Start Guide for further information.
Start Up
1. Installing the SD Card
Before using your Syrius, you will need to install the SD Card included with the device.
The SD Card comes complete with a digital map of the UK and Ireland or Western Europe
depending on the model purchased and is also where the Enigma
camera database is
TM
stored if you choose to subscribe and download it.
Start by moving the 'Batt. ON/OFF' switch located on the underside of the unit to the 'ON'
position, then remove the SD card from its packaging and insert it into the SD Card slot as
indicated. Finally switch on the device by pressing and holding the standby power button
located on the left hand side of the unit for 2 seconds. As soon as the device is switched
on, the Syrius will automatically synchronise with the SD Card. Once the synchronisation
is completed, the SD Card will not function with any other device. Your Syrius is now
ready to navigate and the camera database can be downloaded if necessary.
Please note that if the unit does
not activate when you press and
hold the standby power button for
2 seconds it may require charging.
Refer to the section 'Charging the
internal battery' later in this guide.
SD Card
4 • UK