Honeywell AIRGENIUS 6 HFD360 Serie Mode D'emploi page 4

REMOVING THE IFD ® PARTICLE FILTER
CAUTION: Power OFF the air cleaner, but leave the unit plugged in to electrical
outlet. Wait 60 seconds before removing the rear grille to check the filters.
When the ifD ® Particle Filter is removed, the CHECK FILTERS light will illuminate
(it may already be on if you've been using your air purifier for a while). The
CHECK FILTERS light will shut off when the ifD
unit (after cleaning) and the Electronic Filter Timer will reset back to zero.
• Press down on the tab on the rear grille and pull the grille down and
toward you (Fig. 5). Remove the grille.
• With one hand, hold the air cleaner steady and use your other hand to
grasp ifD ® Particle Filter and pull out (Fig. 6).
• To place the ifD ® Particle Filter back into the air cleaner housing, insert it at the
bottom and ensure it is pushed in as far as it can go. Use one hand to support
the filter at the bottom while pressing the top of the filter into place. You will
hear an audible "click".
• Return the grille to the air cleaner housing. You will hear an audible
"click" when the grille is installed correctly.
• The CHECK FILTERS light will remain illuminated if the ifD
properly seated.
CLEANING THE IFD ® PARTICLE FILTER
The ifD ® Particle Filter should be cleaned every 3 months.
Turn the power off but DO NOT unplug the air cleaner. After removing the ifD
Filter from the air cleaner, follow the steps below to clean the ifD
• Rinse the filter with clean tap water (Fig. 7).
• If the filter still appears dirty, proceed to "Washing," otherwise proceed to "Drying."
Washing:
®
• Remove the ifD Particle Filter from the unit.
• Fill a sink with lukewarm water and add a few drops of mild dish soap.
• Gently swish the filter in the soap solution to clean.
• Soak the filter for 2-3 minutes. DO NOT leave the filter in the water for more than 5 minutes.
• Rinse the filter with clean tap water (Fig. 7). Proceed to "Drying".
Note that the filter may still be discolored even after washing.
This is normal staining that occurs and will not affect performance.
Drying:
• Shake the filter to remove any excess water.
• Place the filter with the honeycomb side down on a plush towel.
• Allow the ifD ® Particle Filter to dry for a few hours or overnight.
• When the ifD Particle Filter is completely dry, place it back into the air cleaner. The CHECK FILTERS light
®
will automatically shut off and the filter timer will be reset
CAUTION:
NEVER place a wet ifD Particle Filter in your air cleaner.
®
• The ifD Particle Filter is NOT dishwasher safe. DO NOT place the ifD
®
subject it to other extreme hot water conditions.
• DO NOT use any solvents, strong cleaning agents or flammable liquids to clean the ifD
6
All manuals and user guides at all-guides.com
Fig. 5
® Particle Filter is returned to the
Fig. 6
® Particle Filter is not
Fig. 7
® Particle
® Particle Filter.
Particle Filter in a dishwasher or
®
® Particle Filter.
REPLACING THE ODOR & VOC REDUCING PRE-FILTER
The AirGenius 6 uses the Odor & VOC Reducing
helps capture large airborne particles that enter the rear grille and also helps trap
common household odors and VOCs (gases).
This pre-filter is not washable and will lose its effectiveness over time. It should
be replaced every 3 months when you clean the ifD
odor and VOC reduction performance.
To remove and replace the pre-filter, remove the rear grille and gently untuck the
filter from the plastic retention clips and dispose of used pre-filter. Remove the
plastic bag and place a fresh pre-filter on the rear grille and tuck the edges
K
under the plastic clips to hold securely in place. Return the rear grille to the air
cleaner.
CLEANING AND STORAGE
We recommend that you clean the air cleaner at least once every 3 months and before extended storage.
Unplug unit from outlet before cleaning. Use only a dry cloth to wipe the external surfaces of the air
cleaner. DO NOT USE WATER, WAX POLISH, OR ANY CHEMICAL SOLUTION.
REPLACEMENT FILTERS
The ifD ® Particle Filter is washable and does not need to be replaced. The Odor & VOC Reducing
Pre-filter (Model HRF-K2) is not washable and should be replaced every 3 months for optimal
K
odor and VOC reduction performance.
To ensure stated product performance, use only Genuine Honeywell Replacement filters.
You may purchase Honeywell replacement Odor & VOC Reducing
Pre-filters from the retailer where you purchased your air cleaner or order
K
directly from www.replacementfilters.com
Odor & VOC Reducing
If you have any questions about the ifD
or email consumerrelations@kaz.com.
Pre-filter. The pre-filter
K
Fig. 8
Particle Filter for optimum
®
Odor & VOC
Reducing
K
Pre-filter
Pre-filter: Model HRF-K2 (2 pack)
K
Particle Filter, call 1-800-477-0457
®
Rear
Grille
7