Accessories; Standard Accessories; Optional Accessories - Hitachi GP 2S2 Instructions De Sécurité Et Mode D'emploi

This Parts List will be helpful if presented with the
tool to the Hitachi Authorized Service Center when
requesting repair or other maintenance. In the
operation and maintenance of power tools, the
safety regulations and standards prescribed in
each country must be observed.
MODIFICATIONS:
Hitachi Power Tools are constantly being improved
and modified to incorporate the latest technological
advancements.
Accordingly, some parts may be changed without
prior notice.
WARNING: ALWAYS use Only authorized HITACHI replacement parts and accessories. NEVER use
replacement parts or accessories which are not intended for use with this tool. Contact HITACHI
if you are not sure whether it is safe to use a particular replacement part or accessory with
your tool.
The use of any other attachment or accessory can be dangerous and could cause injury or
mechanical damage.
NOTE: Accessories are subject to change without any obligation on the part of the HITACHI.

STANDARD ACCESSORIES

(1) Wrench (43/64''(17 mm)) (Code No. 936638) ..... 1
(2) Wrench (15/32''(12 mm)) (Code No. 936553) ..... 1
(3) Side Handle (Code No. 329758) .......................... 1

OPTIONAL ACCESSORIES

Collet chuck (for 1/8''(3.175 mm) shaft)
Dimensions and handling methods other than the
shaft hole are the same as those for the 1/4''(6 mm)
collet chuck.
Case
NOTE:
Specifications are subject to change without any
obligation on the part of the HITACHI.

ACCESSORIES

......... sold separately
English
13