General Safety Instructions For Grinders; Optional Accessories - Hitachi GP 2 Mode D'emploi

English
GENERAL SAFETY INSTRUCTIONS FOR
GRINDERS
– Check that speed marked on the wheel is equal to
or greater than the rated speed of the grinder;
– Ensure that the wheel dimensions are compatible
with the grinder;
– Abrasive wheels shall be stored and handled with
care in accordance with manufacturer's instructions;
– Inspect the grinding wheel before use, do not use
chipped, cracked or otherwise defective products;
– Ensure that mounted wheels and points are fitted
in accordance with the manufacturer's instructions;
– Ensure that blotters are used when they are provided
with the bonded abrasive product and when they
are required;
– Ensure that the abrasive product is correctly mounted
and tightened before use and run the tool at no-
load for 30 s in a safe position, stop immediately
if there is considerable vibration or if other defects
are detected. If this condition occurs, check the
machine to determine the cause;
SPECIFICATIONS
Voltage (by areas)*
Input*
No-Load Speed*
Max. Wheel Diam.*
Collet chuck Capacity**
Weight (without cord)
* Be sure to check the nameplate on product as it is subject to change by areas.
** This varies depending on the area.
STANDARD ACCESSORIES
(1) Wrench (17 mm) ....................................................... 1
(2) Wrench (12 mm) ....................................................... 1
Standard accessories are subject to change without
notice.

OPTIONAL ACCESSORIES

Collet chuck
for 3mm shaft
for 3.175mm(1/8") shaft
for 6.35mm (1/4") shaft
for 8mm shaft
Dimensions and handling methods other than the
shaft hole are the same as those for the 6mm collet
chuck.
Wheels with 6mm shaft
All wheels are provided with WA grain, 60 granding,
and P bonding and are suitable for grinding general
and special steel materials.
4
All manuals and user guides at all-guides.com
(sold separately)
– If a guard is equipped with the tool never use the
tool without such a guard;
– Do not use separate reducing bushings or adapters
to adapt large hole abrasive wheels;
– For tools intended to be fitted with threaded hole
wheel, ensure that the thread in the wheel is long
enough to accept the spindle length;
– Check that the work piece is properly supported;
– Do not use cutting off wheel for side grinding;
– Ensure that sparks resulting from use do not create
a hazard e.g. do not hit persons, or ignite flammable
substances;
– Ensure that ventilation openings are kept clear when
working in dusty conditions, if it should become
necessary to clear dust, first disconnect the tool
from the mains supply (use non metallic objects)
and avoid damaging internal parts;
– Always use eye and ear protection. Other personal
protective equipment such as dust mask, gloves,
helmet and apron should be worn;
– Pay attention to the wheel that continues to rotate
after the tool is switched off.
(110V, 115V, 120V, 127V, 220V, 230V, 240V)
520W
25000 min
25 mm
6 mm
1.75 kg
ø 16
ø 25
ø 6
KA-4
Wheels with 3mm shaft
All wheels are provided with WA grain, 80 granding
and P bonding and are suitable for grinding general
and special steel materials.
ø 10
ø 6
ø 3
KA-20
–1
ø 16
ø 16
KA-5 KA-8 KA-12
ø 6
ø 7
KC-20 KC-22 KC-23
ø 13
KA-13
ø 6
KC-24