Publicité
T-Connector Wiring Kit
INSTALLATION INSTRUCTIONS
1. Read instructions thoroughly before beginning.
2. Locate the vehicles tail light
wiring harness behind the rear
bumper (Fig. 1).
3. Remove the protective dust cover
from the factory harness connector
(Figs. 2A & B). The connector will be
similar in
apearance to that on the
T-Connector harness. If
present, clean away any dirt,
dust or debris from
the connector.
4. Insert the T-Connector
harness end into the factory harness
connector. Firmly press the ends
together until the locking tabs engage.
5. At the front of the vehicle, locate the
main fuse panel under the hood on the left
(driver's) side within the engine
compartment (Fig. 3).
6. Carefully remove the fuse panel
cover and insert three relays into
positions 29, 30 & 31. Insert two 20 amp
Fig. 1
Fig. 2A
Fig. 2B
Fig. 3
Publicité
