Roger Technology AGILIK Serie Instructions Et Avertissements Pour L'installateur page 22

7.3) Installation of the bar
All manuals and user guides at all-guides.com
9
Before installing the bar, ensure that the internal arm for securing the spring is
oriented in the correct direction, according to the arrangement of the barrier
of a right or left installation, as shown in Fig 9.
To install a bar, proceed as described:
Release the geared motor through the appropriate release key supplied
with the barrier (see Chapter 10); manually rotate the arm until it reaches
the proper recommended position, which provides for the ability to vertically
insert the bar, using a removable iron support such as a bar support point,
when inserted
(Ref. "E" Fig. 10). Tighten the geared motor again by turning the key in the
opposite direction and proceed with the assembly of the bar as shown in Fig 10:
Secure the aluminium bar support base (A) with 8 galvanized M10 screws
(B) to the fixing flange that comes out of the geared motor (C). Tighten with
adequate strength.
Rest the bar (D) in its slot and push it in support to the steel plate (E); apply the
three moulded steel flanges (G) and secure with 6 galvanized M10 screws (B).
Tighten with adequate strength. Position the plastic end cap in its slot (F). Now
apply the final aluminium cover (H) and secure it with 6 steel M10 screws (K).
If necessary, reverse the orientation as follows:
Release the geared motor (see Chapter 10); manually rotate the arm until it
reaches the proper position. Tighten the geared motor by turning the key in
the opposite direction.
Now remove the cover of (H), loosen the fixing flange until the bar slides freely,
(G), remove the plastic end cap (F) and slide the bar up to the desired position.
Position the plastic cap and reattach all previously removed or loosened parts.
Note: For correct configuration of the left/right opening of the automatic
barrier, refer to the of the control unit manual AG / CTRL parameter No. 71.
10
A C
E
F
D
G
B
H
B
K
22