Publicité
Les langues disponibles
Les langues disponibles
areas with a large number of obstacles. The sensor is resistant
to dripping water; however, it should not be exposed to sustained
rain. Do not place the sensor on metal objects as these would
reduce transmission range. Use the sensor in vertical position
only. If the weather station screen shows the low battery icon
in the outdoor temperature field, replace the batteries in
the sensor.
6. If the weather station screen shows the low battery icon
the indoor temperature field, replace the batteries in the station.
Manual Time Setting
1. Long press the
2. Use the
time format – hours – minutes.
Confirm each set value by pressing the
speeds up value adjustment.
If no button is pressed within 20 seconds, the unit will return to
the main screen.
Setting °C/°F Temperature Unit
Repeatedly pressing the
between °C/°F.
Screen Illumination
Always power the station using the micro USB cable. Otherwise,
screen illumination will not function!
The batteries are intended only for data backup.
The screen illumination setting can be adjusted by repeatedly press-
ing the SNZ/LIGHT – off/on.
Setting an Alarm
Short-press the
Then, long-press the
flashing.
Use
/
to set the hours and minutes for the alarm; holding the
arrow buttons speeds up adjustment.
Confirm set values by pressing
To activate the alarm, short-press the
on the screen.
button.
/
buttons to set the following parameters: 12 h/24 h
button; AL will appear on the screen.
button again; the time setting will start
button will switch temperature units
.
7
button; holding
button; AL will appear
in
/
Publicité
