Emos E8647 Notice Utilisateur page 6

11 – down arrow button
12 – up arrow button
13 – settings button
14 – battery compartment
15 – micro USB port
Description of the Sensor (Fig. 2)
16 – LED
17 – hole for hanging
18 – battery compartment
19 – RESET button
Attention
Only use 1.5 V alkaline batteries of the same type; do not use re-
chargeable 1.2 V batteries.
The lower voltage may cause both of the units to not function.
Getting Started
1. Insert batteries first into the weather station (2× 1.5 V AAA),
connect the micro USB cable (included) to a USB power adapter
(not included) and the station, then plug the adapter into a socket.
2. Then insert batteries into the wireless sensor (2× 1.5 V AAA).
Make sure the polarity is correct when inserting the batteries
to avoid damaging the weather station or sensor.
3. Place the two units next to each other. The
ing on the screen; the weather station will detect the remote
sensor signal within 3 minutes. If sensor signal is not detected,
proceed again from step 1 or use a thin object (e.g. a pencil or a
paper clip) to press the RESET button on the back of the sensor.
4. If the outdoor temperature reading disappears from the screen,
long press the
searching for the sensor signal. If the station loses the signal
from the sensor for a period longer than 1 hour, the outdoor
temperature and humidity value will start flashing on the screen.
Long-press the
searching for the sensor signal again.
5. We recommend placing the sensor on the north side of the
house. The range of the sensor may decrease substantially in
button on the station. The station will start
button on the station so that the station starts
6
icon will be flash-