Publicité
Les langues disponibles
Les langues disponibles
O P E R A T I N G I N S T R U C T I O N S
Design Column Heater
Item-No. 56 10 79
Proper use according to manufacturer's instructions
With the integrated heating module and the fan, the fan heater generates a warm airstream for
heating. Two heating levels (2 x switches each 1000W; the total capacity is 2000W when
activating both switches) are available. Furthermore, the product has a switchable swivel
mechanism (switch „SWING") a cold air function (switch „FAN").
This product is only approved for connection to 230V~/50Hz alternating current. The fan heater
can only be used in dry interiors; it must not get damp or wet.
Any use other than that described above will damage this product and may involve risks such as
short-circuit, fire and electric shock. Do not change or modify any part of the product!
Please read the operating instructions completely and observe the safety and operating instruc-
tions before and during use of the product!
This product complies with the applicable National and European specifications. All names of
companies and products are the trademarks of the respective owner. All rights reserved.
Features
• Two heating levels (2 x switches each 1000W; the total capacity is 2000W when activating
both switches) are available.
• Switchable swivel mechanism can be activated with the switch „SWING".
• Mounting on the ground
• The internal fan can be activated/deactivated (switch ON/OFF/FAN)
Explanation of the Symbols
A lightning-bolt symbol in a triangle indicates a health hazard, e.g. danger of elec-
tric shock.
The exclamation mark in a triangle indicates a particular risk during handling, oper-
ation and control.
The „Hand" symbol indicates special tips and operating information.
Do not cover the item with objects such as a curtain to avoid overheating.
Safety Instructions
The warranty will be void in the event of damage caused by failure to observe
these safety instructions. Liability for any and all consequential damage is
excluded!
We rare not liable for any damage to property or personal injury caused by
improper handling or non-compliance with the safety instructions. The war-
ranty will be null and void in such cases.
• The unauthorised conversion and/or modification of the product is inadmissible
because of safety and approval reasons (CE). Do not open/disassemble! There
are no parts inside that need to be adjusted or maintained by you.
Maintenance, adjustment or repair work may only be carried out by a specialist/
specialist workshop.
• The product is designed according to safety class I. It must only be operated on
a mains earthed socket.
• For the power source, only a 230V~/50Hz (10/16 A) mains outlet with a protec-
tive earth may be used. Never try to operate the device with any other voltage.
• The product is only designed for use in dry indoor locations, it must not get damp
or wet, lethal danger through electric shock!
Never set up the product in the direct vicinity of a bathroom, a shower, a bathtub
or the like.
• Never plug, unplug, touch or use the product with damp or wet hands.
• Never use the fan heater in vehicles of any kind and similar mobile locations or
rooms.
• Hold the plug by the intended gripping surface when pulling it out of the socket.
Do not pull the cable.
• The product does not contain an integrated thermostat for regulating the room
temperature. Turn off the product in time! Danger of fire!
• The product is not a toy and must be kept out of the reach of children. Be specially
careful if children are around. Children cannot see the danger arising from incor-
rect use of electrical devices. Children could try to insert items into the device.
There is a risk of a lethal electric shock! Furthermore there is a high risk of injuries
from the hot surfaces; danger of fire!
Install the product out of the reach of children.
All manuals and user guides at all-guides.com
www.conrad.com
Version 05/10
°
• Unwind the mains cable completely. If the cable is not unwound completely, it
can cause overheating; danger of fire!
• The power cable must not be pinched or damaged by contact with sharp edges.
Do not place any objects on the mains cable, do not step on it.
• Install the cable where no one can stumble over it and the plug is easily
accessible.
Do not install the mains cable under carpets or the like.
• Do not use any extension cables, no loads and no dimmers or the like. Insert the
mains plug directly into a mains socket e.g. a wall socket. Do not connect the fan
heater to a timer or a circuit that is switched.
• Do not use the product when it is damaged (e.g. housing, mains cable). A defect-
ed connection cable must only be replaced by a specialist. Danger of a lethal
electric shock!
• For reasons of safety, pull the mains plug out of the mains socket before clean-
ing the device, during a thunderstorm or when the device is not used for a long
time.
• Always leave space of at least 1.5 m from combustible or flammable materials
or objects (curtains, doors, furniture etc.). If the distance is too short, there is a
risk of fire.
• Never cover the product! Do not touch the openings in the product; do not put
objects in the openings. Danger of lethal electric shock; danger of fire!
• Never pour any liquids on or next to the product. You run the risk of causing a
fire or a fatal electric shock. However, if liquids get into the device, immediately
isolate the mains socket (fuse), then remove the mains plug from the mains
socket and consult an expert. Do not operate the product anymore.
• Do not operate the device in environments where there are high levels of dust,
flammable gases, vapours or solvents. There is a danger of fire and explosion!
• Never place the product on an unstable or movable surface. Always set up the
fan heater in such a way that it cannot cant or fall. Canting/falling causes danger
of fire and persons can be injured or the product could be damaged. The stand
at the bottom of the device has an integrated safety switch which would deacti-
vate the product, but will not alleviate the danger of fire caused by the hot sur-
face of the IR-heater.
• Do not operate the product when it is unattended.
• The air outlet will become very hot within a short period of time; danger of being
burnt! Take the necessary care in using the heater.
• When using the heater for the first time, heated parts of the casing could cause
an irritating odour for some time. If you experience this, ventilate the room where
the fan heater is set up.
• Only move, transport or store the product when it has cooled down completely.
Disconnect from the mains voltage, pull the plug out of the power socket.
• Only use the device in a temperate climate, never in a tropical climate.
• Do not carelessly leave the packaging material lying around since this may
become a dangerous toy for children.
• Never plug the product directly after transferring it from a cold room to a warm
one. The condensation that develops in such cases could damage the device or
cause an electric shock. Allow the appliance to reach room temperature. Wait
until the condensation has evaporated. This might take several hours. Only after
this should it be plugged into the mains supply and put into use.
• The product is not suitable for commercial use.
• If in doubt about how to connect the device correctly, or should any questions
arise that are not answered in these operating instructions, please contact our
technical advisory service or another specialist. Please consult a specialist if you
have any doubts regarding the use or safety of the product.
• The product may not subjected to strong vibrations, heavy mechanical strain,
direct sunlight or high degrees of humidity.
This may damage the product and cause a lethal electric shock.
• Only a specialist who is familiar with the risks and relevant regulations may carry
out repairs or open the appliance. Only original replacement parts may be used.
• Handle the product with care, it can be damaged by impacts, blows, or acciden-
tal drops, even from a low height.
• Do not cover the item with objects such as a curtain to avoid overheating.
• Do not use the product in the direct vicinity of a bathtub, a shower or a swimming
pool.
• Do not set up the product directly beneath a wall socket.
• Do not start using the product when it is damaged.
• Pull out the mains plug out of the mains socket before cleaning the product.
• Do not use the product in combination with a timer, a separate remote control or
other means to automatically switch on the product. This might cause a fire
when the product is covered or wrongly set up.
Publicité
