Publicité
Les langues disponibles
Les langues disponibles
Drying
• Lower the squeegee by operating the lever (fig. 16, ref. 2).
• Press the suction control button to activate the vacuum function, and pass over the area
washed previously: this will produce an effect similar to a thorough scrub, with the result that
subsequent routine maintenance work on the floor will be less time-consuming.
Removal of dirty water tank lid
• Release the lid of the dirty water tank by pressing the two sliding catches toward one another
(fig. 19, ref. 1).
• Lift off the lid.
Installation of dirty water tank lid
INFORMATION: INCORRECT positioning of the lid on the dirty water tank will cause the machine to
malfunction when the floor is being dried.!
• Place the lid on the tank.
• Apply downward pressure to the lid, sufficient to make certain that the two sliding
release catches spring outwards and engage with the top of the dirty water tank
(Fig.20).
INFORMATION: The lid is correctly installed when the RED
presented by the recesses of the two catches can NOT be seen (fig.
Filling the water/detergent
! INFORMATION: Remember to empty the dirty water
every time the clean water and detergent tank is
The tank can be filled in two different
Tank installed on the machine:
• Turn off the machine at the main switch.
• Remove the cap of the detergent tank (fig.21, ref. 1).
• Fill the tank.
Tank removed from the machine:
• Turn off the machine off at the main switch.
• Press in the two lateral tank retaining catches (fig. 22, ref. 1), separate the dirty water
tank from the frame and set it down on the floor.
• Remove the cap of the detergent tank.
• Separate the detergent tank from the frame.
• Fill the tank (fig. 23).
12
Parts & Operations Manual
All manuals and user guides at all-guides.com
Micro-5
background
20).
tank
tank
filled.
ways:
Publicité
