CAME 001SDTE Mode D'emploi page 10

English
DESCRIPTION
001SDTE is a double technology sensor (passive infrared and
microwave), hard-wired for outdoors.
The alarm is generated when both technologies detect
together.
The sensor is tamperproof protected thanks to its built-in
anti removal system.
Installation precautions
This sensor is designed to operate in very bright settings. The
sensor, however, must not be exposed to direct beams of very
high intensity light.
We suggest installing the sensor in areas protected from
weather agents.
To maintain the protection degree, you must use o-rings
and issued screws when installing.
Otherwise the product could malfunction, and the manufac-
turer declines any liability in this case. The sensor can detect
animal presence.
Technical data
Type
Power supply [V]
Draw while standing-by [mA]
Draw while in alarm state [mA]
Microwave operating frequency [GHz] 24
Maximum range at 25°C [m]*
Minimum range at 25°C [m]*
Alarm output
Tamper output
10 - 119RW88 ver.2 07-14
All manuals and user guides at all-guides.com
Operating temperature [°C]
Relative humidity [%]
Weight [g]
Dimensions [mm]
Protection rating [IP]
Impact resistance [IK]
*The maximum range greatly depends on the outside
temperature.
Features
A
LED
LED Color
 DL1 Red
 DL2 Red
 DL3 Blue
Dipswitch 
001SDTE
8 ÷ 14 DIP4 (LED and BUZZER adjustments)
Buzzer, DL1, DL2 disabled.
< 8.5
The DL3 is managed by jumper JP3.
OFF
50
ON
Buzzer, DL1, DL enabled.
18
DIP5-DIP6 alk test
3
Normal operation
OFF
Optomos NC
ON IR walk test (DL1 stays on, DL3 notifies of
NC contact
detection)
OFF
-40 ÷ 70
95
The walk tests are for making detection area adjustments
440
to the sensor. Infrared and microwave adjustments are
190x85x75
independent.
54
10
DIP7 (IR range)
Every time DIP7 is moved, you need to wait 10÷20 seconds
for the sensor to stabilize into the new position.
Meaning
IR detection
Jumpers
 JP1: Enabling/disabling the antiopening Tamper
Microwave detection
JP1 OPEN: tamper enabled JP1 CLOSED: tamper di-
Alarm
 JP2: Enabling/disabling the anti-removal Tamper
JP2 OPEN: tamper enabled JP2 CLOSED: tamper di-
DEFAULT
 JP3: Enabling/Disabling the alarm LED DL3
JP3 OPEN: LED disabled
Trimmer
 RV1: adjusting the detection range of the upper head
(infrared). Turn clockwise to increase range.
 RV2: adjusting the detection range of the lower head
(microwave). Turn clockwise to increase range.
NOTE. Before powering up the sensor, make sure that
RV1 and RV2 have been adjusted to maximum range
(turned completely clockwise). Otherwise the sensor
ON MW walk test (DL2 stays on, DL3 notifies of
detection)
OFF
Max range about 18 m. Adjusting the max range
ON
(via RV1) = about 9 ÷ 18 m
Max range about 12 m. Max range adjustment
(via RV1) = about 3 ÷ 12 m
OFF
sabled
sabled
JP3 CLOSED: LED enabled