Busch-Jaeger Busch-Transcontrol HF 6866 AG Manuel D'utilisation page 45

All manuals and user guides at all-guides.com
Operation
When HF Receiver 6866 AG is switched ON via the HF Manual Transmitter, the
connected consumers remain switched on. Order from the Transmitter Module
are only permitted again after the Receiver is switched OFF via the HF Manual
Transmitter.
• Signal received:
• No signal received:
d. Pushbutton Mode (Coding Switch Position 5 to 7)
In this operating mode, contrary to Switch Mode, an output pulse of approx.
1 second is generated. In the case of the HF Manual Transmitter, this output pulse
is transmitted to a send address via the ON and OFF buttons.
• Signal recived:
NOTE
The pulse duration is dependent on the "operating time" of the respective button
on the HF Manual Transmitter.
The "ALL OFF" button has no function.
CAUTION
The following step is only permissible in rotary switch position 8 and 9.
Otherwise there is a risk that, when operating, the blind motor will be
destroyed.
e. Blind Mode (Coding Switch Position 8 and 9)
(Only possible in conjunction with Busch Transcontrol
Irrespective of the operating time, the following possibilities are available to
control your blinds, etc. Press:
• ON:
• OFF:
• Counter-order to
OFF or ON:
• ALL OFF:
- Relay switches on
- Relay switches off after approx. 15 seconds
- Relay switches on for approx. 1 second
- Blind moves upwards; travel time approx. 3 minutes
- Blind moves downwards; travel time approx. 3 minutes
- Blind stops
- no function
®
HF Manual Transmitter)
GB