HoMedics Soft as Silk Mode D'emploi page 3

PRODUCT FEATURES
Extra coarse
roller: white edge
Coarse roller:
blue edge
Cleaning brush
Fine roller: grey edge
(where supplied)
Main body
INSTRUCTIONS FOR USE:
Charging the batteries
When the level indictor LED flashes red, the
product needs charging. Connect the charging
base to a USB power supply using the lead
provided. Place the unit in the charging
base. The LED light will flash to indicate that
charging is taking place. When charging is
complete green LED will stay on. It takes 2
hours for a full charge, which will provide 90
minutes use, dependent on power levels used.
How to use
1. Ensure that your feet are clean and dry.
2. Use the switch to select a power setting;
For sensitive skin, or softer skin use the LO
setting.
For harder skin use the HI setting.
3. Using light pressure place the surface of
roller onto the heel or sole of your foot and
gradually move the device around to target
areas of hard skin. Do not use on a single
area for more than 4 seconds at a time.
4. Check the results throughout. Once you are happy with the results
turn the switch to OFF.
5. Rinse your feet with clean water & dry before applying your
favourite foot cream.
Cautions
Before use, make sure that the roller is in good condition. Any
malformation, distortion or damage may cause skin injury.
DO NOT APPLY EXCESS PRESSURE OR CAUSE THE MOTOR TO STOP
ROTATING. FOR BEST RESULTS, RUN THE UNIT GENTLY OVER THE SKIN.
THIS WILL ENSURE SOFT, SAFE AND SMOOTH REMOVAL OF DEAD SKIN.
All manuals and user guides at all-guides.com
Release button
Power switch
LIGHT APPEARANCE MEANING
Red LED On Device on and battery low
Red LED Flashing Battery charging
Green LED On Device fully charged
LED Off Device not in charging base and is switched off
Changing the rollers
To remove the roller.
1. Ensure the switch is in the OFF position.
2. With one hand press the release button on
the side of the device.
3. With the other hand lift out the roller.
TIP: It's easier to lift the roller out from the
end closest to the release button.
To insert a new roller.
1. Loosely position one of the roller pins into the recess on the end
furthest from the release button.
2. Push the other end of the roller into place using the groves to guide
it into position.
3. The roller will secure into place with a click.
MAINTENANCE AND STORAGE
• Always turn the device off before cleaning it.
• Only clean the device with the supplied brush or a dry cloth. Do not
use chemical agents including benzene, alcohol etc.
• Batteries (battery pack or batteries installed) shall not be exposed to
excessive heat such as sunshine, fire or the like.
• Your PED 1300 includes a rechargeable battery designed to last the
lifetime of the product. In the unlikely event that you should require
a replacement battery please contact Customer Services who will
supply details of the warranty and out-of-warranty replacement
battery service.
• If roller surface becomes worn or less abrasive, fit a new roller.
GB
3 I
Charging station
Storage for
USB charging
replacement
cable
rollers