Hkoenig bw1890 Manuel D'instructions page 10

INSTALLATION & OPERATION
A. INSTALLATION
Take out the beer cooler from its package. Place the beer cooler
1.
on a steady and horizontal surface, and make sure the beer
cooler is at least 5 inches/10 cm away from other appliances or
wall on each side so as to allow correct ventilation on the
appliances to get better performance.
Figure 6
Install the tap handle connect the tap, make sure both end fit
2.
together perfectly. (Show as Figure 6)
Set the water drip tray into the notch provided. (Show as
3.
figure 7)
Plug the beer cooler.
4.
Note: Do not connect or disconnect the electric plug when your
hands are wet. Before use it, make sure the voltage is conformity
with plug mark, and check whether the power cord is well connected
or not; if not, please don't use it, and call service center.
Drip tray
Handle
Faucet
Figure 7