Publicité
Les langues disponibles
Les langues disponibles
Disposal
A lithium-ion polymer rechargeable battery is built in to the 3D Eyewear. Please discard according to local regulations.
When disposing this product, disassemble properly by following the procedure below, and remove the internal
rechargeable battery.
Do not disassemble this product except when disposing of it.
Danger
●
As the rechargeable battery is specifically for this product, do not use it for any other device.
• Do not charge the removed battery.
• Do not throw the battery in a fire, or apply heat to it.
• Do not pierce the battery with a nail, subject it to an impact, or dismantle or modify it.
• Do not let the wires touch any other metal or each other.
• Do not carry or store the battery with a necklace, hair pin, or the like.
• Do not charge, use, or leave the battery in a hot location such as near a fire or under the hot sun.
Doing so may cause the battery to generate heat, ignite, or rupture.
Warning
●
Do not place the removed battery, screws, and other items within reach of infants.
Accidental swallowing of such an item may have an adverse effect on the body.
• In the event that you think such an item has been swallowed, consult a doctor immediately.
●
In the event of fluid leaking from the battery, take the following measure, and do not touch the fluid with bare
hands.
Fluid entering into an eye may cause loss of eyesight.
• Wash the eye with water immediately without rubbing it, and then consult a doctor.
Fluid getting on your body or clothes may cause inflammation of the skin or injury.
• Sufficiently rinse with clean water, and then consult a doctor.
How to remove the battery
Disassemble this product after the battery has run out of power.
The following figures are intended to explain how to dispose of the product, not for describing how to repair.
The product cannot be repaired once it has been disassembled.
1. Fold the part of the
frame without the power
switch, and then remove
the two screws on the
inside of the hinge with a
precision Phillips (plus + )
screwdriver.
2. Bend the frame inwards
and pull it off from the side
cover.
• If it is difficult to remove,
insert a flat-blade (minus - )
screwdriver and force it off.
60
All manuals and user guides at all-guides.com
3D Eyewear
Screws
Frame
Side cover
Battery
3. Remove the battery from
inside the side cover, and
cut the two wires one by one
with scissors.
• Insulate the wire parts of
the removed battery with
cellophane tape.
Note
●
Take sufficient care when performing this work so as not
to injure yourself.
●
Do not damage or dismantle the battery.
Publicité
