NOCO Genius G750EU Guide D'utilisation Et Garantie page 4

For charging 12-volt Wet Cell, Gel Cell, Enhanced Flooded, Maintenance-Free and Calcium batteries. When selected, a
12V
white LED will illuminate.
NORM
14.5V | 750mA | Up To 30Ah Batteries
6V
For charging 6-volt Wet Cell, Gel Cell, Enhanced Flooded, Maintenance-Free and Calcium batteries. When selected, a
NORM white LED will illuminate.
Press & Hold
7.25V | 750mA | Up To 30Ah Batteries
Using 6V NORM. [Press & Hold]
6V NORM charge mode is designed for 6-volt lead-acid batteries only, like Wet Cell, Gel Cell, Enhanced Flooded, Maintenance-Free and Calcium
batteries. Consult the battery manufacturer before using this mode. CAUTION. THIS MODE IS FOR 6-VOLT LEAD-ACID BATTERIES ONLY.
Connecting to the Battery.
Do not connect the AC cable until the connection of the battery is made first. Do not make any connections to the carburetor, fuel lines, or thin
sheet metal parts. The below instructions are for a negative ground system. If a positive ground system (very uncommon), follow the below
instructions in reverse order.
1.) Connect the positive (red) battery connector to the positive (POS,P,+) battery terminal.
2.) Connect the negative (black) battery connector to the negative (NEG,N,-) battery terminal or vehicle chassis.
3.) Connect the battery charger's AC power plug into a suitable electrical outlet.
4.) When disconnecting the battery charger, disconnect in the reverse sequence.
Begin Charging.
1.) Verify the voltage and chemistry of the battery.
2.) Confirm you are properly connected to the battery and plugged into an AC electrical outlet.
3.) The charger begins in Standby mode (Orange LED), and not providing any power.
4.) Press the mode button to toggle to the appropriate charge mode for the voltage and chemistry of your battery.
5.) The mode LED will illuminate the selected charge mode and the Charge LEDs will illuminate indicating the charging process has started.
All manuals and user guides at all-guides.com