Ayce KSE 40/2400 Traduction De La Notice Originale page 114

All manuals and user guides at all-guides.com
Start up
1. Remove the bar cover.
2. Release the chain brake by pulling the front hand guard (5). Firmly towards the back of
the electric chain saw until a click is heard, to check the chain brake has been released,
you should be able to move the chain by hand. (fig.14&fig.15)
3. Connect the cable to the power.
Note: ensure the brake is working efficiency. Check its operation every time you use the
chain saw before commencing work with it.
the on/off switch ever be depressed before pulling back the front hand guard.
4. Hold the electric chain saw by its grip with both hands.
5. To start the chainsaw, press the lock-off button on the trigger switch.
6. To stop the chain saw, release the trigger switch.
hold the electric chain saw with both hands until the chain is completely still.
While cutting, always:
- Run the chainsaw motor at full revs, this makes the job safer, as these is less chance of
pull-in or kick-back.
- Position your body to the left of the chainsaw so if it kicks back uncontrollably. It goes
over your right shoulder.
- Keep a firm grip with your left hand on the front handle, with your thumb securely below
the handle. The swivel of your wrist in a kick-back situation will activate the chain brake.
- Make sure the chain is tensioned correctly.
fig.14 fig.15