Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
4. Tighten oil cap firmly for good seal, this will avoid oil seepage from tank.
5. Wipe off excess oil.
it is normal for oil to seep when saw is not in use. Empty oil tank after each use to
prevent seepage.
• Check the automatic operation of the chain lubrication by pointing the tip of the switched
–on saw towards a piece of paper laying on the ground, if a patch of oil appears and
becomes larger, then the automatic oil function is working. If there are no traces of oil
even though the oil tank is full. Then the automatic oil function is not working .
• If the automatic oil function is not working. remove the chain bar and clean out the oil
ways of the chainsaw and chain bar, on reassemble if the chainsaw is still not working
take it to a authorized if the chainsaw is still not working take it to an authorized service
centre.
•
kickback may occur when the nose or tip of the guide bar touches an object,
or when the wood closes in and pinches the saw chain in the cut. Tip contact in some
cases may cause a lightning fast reverse reaction. Kicking the guide bar up and back
towards the operator, pinching the saw chain along the top of the guide bar may push the
guide bar rapidly back towards the operator, either of these reactions may cause you to
lose control of the saw which could result in serious injury to user.
• Kickback safety devices on this saw (fig.13).
• This saw has a low-kickback chain and reduced kickback guide bar , both items reduce
the chance of kickback, kickback can still occur with this saw.
• Properly install front hand guard, this item can reduce injures from kickback, do not
remove front hand guard, do not replace front hand guard with substitute.
• The following steps will reduce the risk of kickback:
- Use both hands to grip saw while saw is running. Use firm grip. Thumbs and fingers
must wrap around saw handles.
- Keep all safety items in place on saw make sure they work properly.
- Do not overreach or cut above shoulder height.
- Keep solid footing and balance at all times.
- Stand slightly to left side of saw. This keeps your body from being in direct line with
chain.
- Do not let guide bar nose touch anything when chain is moving
110 , 111
Publicité
