FRICON SMR Serie Mode D'emploi page 37

SMR
CAUTION
The use of gloves is required during cleaning. The sharp extremities of the
equipment may cause cuts on hands.
Cleaning the Interior:
• Remove all products from inside the appliance.
• Disconnect the equipment from the electrical current for the time needed to
defrost the appliance walls completely.
• Clean the equipment with a soft cloth upon defrosting.
• Wash the interior with pure water, to which a little neutral detergent may be
added.
• Dry with a soft cloth.
• Connect and wait for the appliance to reach operational temperature once
again.
• Place the products inside.
Cleaning the Exterior:
• Clean the equipment's exterior with a soft sponge soaked in warm water and
soap.
• Then clean with a soft cloth and dry.
• The refrigerator circuit's exterior (compressor, condenser, connection tubes,
and remaining components) must be cleaned with a soft brush or vacuum
cleaner.
• Pay special attention while cleaning the condenser. If obstructed, it will affect
the equipment's performance.
• While cleaning, be careful not to twist the tubes or disconnect cords.
Cleaning Glass Lids:
• Cleaning with cloth with abrasive microfibers and all types of coarse sponges
is prohibited.
• Make sure that large quantities of water are not applied on the glass surfaces
to be cleaned and that the surfaces are thoroughly dry afterward.
All manuals and user guides at all-guides.com
36
English