Publicité
Les langues disponibles
Les langues disponibles
SYMPTOM
POSSIBLE CAUSE
Lights will not come
1. Light switch is turned off.
on.
2. Flood light is loose or
burned out.
3. Fuse is blown or circuit breaker
is turned off.
4. Daylight turn-off is in effect (Re-
check after dark) .
5. Incorrect circuit wiring, if this is a
new installation.
6. Re-aim the sensor to cover de-
sired area.
Lights come on
1. Light Control may be installed in
in daylight.
a relatively dark location.
2. Light Control is in Test.
(Set control switch to an
ON-TIME position) .
Lights come on for
1. Light Control may be sensing
no apparent rea-
small animals or automobile traf-
son.
fic (Re-aim sensor) .
2. R a n g e i s s e t t o o h i g h .
(Reduce Range) .
3. Dual Brite™ Timer is on.
Lights turn off too
1. Sensor is in a relatively dark
late in Dusk-to-
location. (Relocate sensor, or
use 3 hr or 6 hr setting.)
Dawn setting
See your Canadian Tire retailer for warranty information.
All manuals and user guides at all-guides.com
TROUBLESHOOTING GUIDE
If you experience a problem, follow this guide.
SYMPTOM
POSSIBLE CAUSE
Lights stay on
1. A flood lamp is positioned too close
continuously.
to the sensor or pointed at nearby
objects that cause heat to trigger the
sensor. (Reposition the lamp away
from the sensor or nearby objects) .
2. Light Control is pointed toward a heat
source like an air vent, dryer vent, or
brightly-painted heat-reflective surface.
(Reposition sensor. Reduce Range) .
3. Light Control is in Manual Mode.
(Switch to Auto.)
Lights flash on
1. Heat or light from the lamps may be
and off.
turning the Light Control on and off.
(Reposition the lamps away from the
sensor) .
2. Heat being reflected from other ob-
jects may be affecting the sensor.
(Reposition sensor) .
3. Light Control is in the Test mode and
warming up. (Flashing is normal un-
der these conditions. Turn Boost off.)
4. Light may be leaking through the
floodlamp reflectors. (Replace the
lamps with new high quality PAR 38
lamps or make sure the metal lamp
protectors are installed) .
Lights flash
1. Sensor is detecting its own lights.
once, then stay
(Reposition lamps to keep area be-
off in Manual
low the sensor relatively dark.)
Mode.
4
598-1001-01
Publicité
