Publicité
Les langues disponibles
Les langues disponibles
d)
Programmable timer value: - ? minutes
Operation mode: - Count-down repeat
Press [START/STOP] to start the timer. The timer will start counting down. The display
will also show a flashing
to denote the operation.
When the timer counts to zero, the programmed time will be reloaded and the next count-
down cycle repeats.
Timer Audible Signals
The timer has short audible signals for each full minute. During the 5,4,1,0 sequence
there is a more pronounced audible at minutes 4 and 1. In all count down settings the
last minute has a comprehensive audible warning sequence.
The "Synchronize" feature :-
The "Synchronize" feature is active only when the timer is counting down. Once the timer
is started, you may feel that you were late starting your watch and that consequently your
watch is a few seconds late. You may even have missed the preparatory signal
altogether. This is why we need the "Synchronize" feature in the watch.
When the next signal is given by the race officer, just press [SYNC] and the display will
drop down to the next full minute in countdown. For example, if the watch shows 4'08",
pressing [SYNC] will send the watch to 4'00" and it will continue to count down.
Likewise if the watch shows 3'35" or even 3'59" and you press [SYNC], the time will
jump to 3'00" directly. Therefore the [SYNC] button can be used to get your starting
sequence quickly in perfect unison with the official starter.
Timer Audible Signal enable / disable :-
The default setting for the timer audible signal is enabled and the
If you want to use the watch purely as a visual reference only, it is possible to silence
the audible signal by pressing [CLEAR] for 3 seconds in Timer mode or vice versa if
the audible signal is originally OFF. The
I n s t r u c t i o n s
10
All manuals and user guides at all-guides.com
icon will be visible.
icon will appear and disappear alternately.
E N G L I S H
LOW BATTERY INDICATOR
The timer is equipped with a low battery indicator located just
above the right hand two digits of the lower row of 6 digits.
When the indicator is on, it is time to change the battery. It is
likely that the watch will function for several days with the
indicator on.
TO CHANGE THE BATTERY
1.
Take note of which way up the caseback fits. Using a cross-point screwdriver
carefully remove all screws from the timer, and remove the case back from the case
front to reveal the battery.
2.
There is a protective label over the battery. This is required for insulation purposes
and must be replaced when the new battery has been fitted
3.
Remove the old battery and replace it with a new one making sure that the +ve
contact faces upwards. (Avoid holding the battery so that your fingers touch both
the +ve and -ve contacts at the same time).
E N G L I S H
I n s t r u c t i o n s
11
Publicité
