DeWalt D28111 Manuel D'instructions page 27

• Extensive use of flap discs in metal applications
can result in the increased potential for electric
shock. To reduce this risk, insert an RCD before
use and clean the ventilation slots daily by
blowing dry compressed air into the ventilation
slots in accordance with the below maintenance
instructions.
Labels on tool
The following pictographs are shown on the tool:
Read the instruction manual before use
Wear safety glasses
Wear ear protection
Package contents
The package contains:
1 Angle grinder
1 Guard
1 Side handle
1 Flange set
1 Two-pin spanner
1 Kitbox (K-models only)
1 Instruction manual
1 Exploded drawing
• Check for damage to the tool, parts or
accessories which may have occurred during
transport.
• Take the time to thoroughly read and understand
this manual prior to operation.
Description (fig. A)
Your angle grinder D28111/D28113(K)/D28130/
D28132/D28134/D28135(K)/D28139/D28141 has
been designed for professional grinding and cutting
applications.
1 On/off switch
2 Spindle lock
3 Guard
4 Side handle
All manuals and user guides at all-guides.com
D28113(K)/D28130/D28132/D28135(K)/D28141 -
Anti-vibration side handle
The anti-vibration side handle offers added comfort
by absorbing the vibrations caused by the tool.
D28113(K)/D28130/D28132/D28134/D28135(K)/
D28141 - Keyless guard
The keyless guard allows for quick adjustment during
the application to enhance application versatility.
D28113(K)/D28130/D28132/D28134/D28135(K)/
D28141 - Dust ejection system
The dust ejection system prevents dust pile-up
around the guard and motor inlet, and minimises the
amount of dust entering the motor housing.
Electrical safety
The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
Mains plug replacement
(U.K. & Ireland only)
• Should your mains plug need replacing and you
• Disconnect the plug from the supply.
• Cut off the plug and dispose of it safely; a plug
• Only fit 13 Amperes BS1363A approved plugs
• The cable wire colours, or a letter, will be marked
• Before replacing the top cover of the mains plug
Your D WALT tool is double insulated in
E
accordance with EN 50144; therefore no
earth wire is required.
are competent to do this, proceed as instructed
below. If you are in doubt, contact an authorized
D WALT repair agent or a qualified electrician.
E
with bared copper conductors is dangerous if
engaged in a live socket outlet.
fitted with the correctly rated fuse (1).
at the connection points of most good quality
plugs. Attach the wires to their respective points
in the plug (see below). Brown is for Live (L) (2)
and Blue is for Neutral (N) (4).
ensure that the cable restraint (3) is holding the
outer sheath of the cable firmly and that the two
leads are correctly fixed at the terminal screws.
E N G L I S H
27