JVC DLA-G150CLE Manuel D'instructions page 64

Replacing the Light-Source Lamp
I Resetting the Lamp Use Time
After replacing with a new light-source lamp, reset the lamp-time counter inside the projector to clear the accumulated lamp
time to zero (0). After resetting, a new count will start for the new light-source lamp.
I Projector's button
LAMP TEMP
4
HIDE
HIDE
button
KEYSTONE
PRESET
3
EXIT
button
EXIT
Cursor buttons 5/∞
62
All manuals and user guides at all-guides.com
1
STAND BY
indicator
STAND BY
OPERATE
2
OPERATE
indicator
1
1 Momentary press the PC button.
PC
PC
button
2 Momentary press the ENTER button.
VIDEO
MENU
MENU 3 Momentary press the EXIT button.
button
4 Press and hold the HIDE button for two seconds
2
ENTER
button
ENTER
* During this sequence, the STAND BY and OPERATE
* Buttons must be pressed within 2 seconds of the previous
* When you make a mistake in button operations, return to
* To check the lamp time on the menu, press the MENU button
Video main menu
PC main menu
• Reset the lamp use time only when you have replaced with
Turn on the MAIN POWER switch to go
into stand-by mode.
In stand-by mode, the STAND BY indicator on the
projector lights up.
Press the following buttons on the
projector, sequentially.
or more.
indicators alternately blink about every approx. 3 seconds.
After completion of the sequence, the STAND BY indicator
alone stays on.
button.
the beginning of the sequence.
and select "Information" with the cursor button 5 or ∞ .
The lamp use time is indicated in the item "Lamp time".
Menu
Image adj.
VIDEO
Input
Setting
Switcher CH.0
Color temp.
Source NTSC
Options
Language
Lamp time 123 h
Information
Menu
Image adj.
PC 1
Input
Setting
Switcher CH.0
Color temp.
Resolution 1280 1024
Frequency H
79.9 kHz
Options
Frequency V 75 Hz
Language
Lamp time 123 h
Information
CAUTION
a new light-source lamp. Never reset it during lamp life,
otherwise the replacement time may become unclear, and
lead to degraded performance or lamp explosion.
Lamp time (0 h)
Lamp time (0 h)