Publicité
Step 7
Turn three BLACK 9/16" FLAT HEAD SCREWS (DDD)
å
into the MODESTY PANEL (G) until the shoulder of the
SCREWS rest on the surface of the MODESTY PANEL.
NOTE: Do not overtighten the SCREWS.
å
Now, slide the MOLDING (Y) onto the MODESTY
å
PANEL (G). To do this, line up the groove in the MOLDING
over the head of the SCREWS in the MODESTY PANEL.
Using your hands, apply pressure on the MOLDING as
you guide the MOLDING onto the MODESTY PANEL.
NOTE: If the MOLDING comes up off of the SCREWS,
å
remove it and slide it on again.
These edges
should be even.
Y
Apply pressure with your hands
as you guide the MOLDINGS over
the SCREWS and onto the ENDS.
Page 12
BLACK 9/16" FLAT HEAD SCREW
(3 used in this step)
G
Shoulder
408920
DDD
www.sauder.com/services
Publicité
