Publicité
Les langues disponibles
Les langues disponibles
[AGC - ON/OFF] Auto-gain control switch
6
Setting this switch to "ON" automatically
increases the sensitivity even when the
brightness of the subject is insufficient.
(Default setting: ON)
[BLC - ON/OFF] Backlight
7
compensation switch
Setting this switch to "ON" opens the iris
even in backlight conditions, making the
subject easier to view.
(Default setting: OFF)
[AUTO/MANU] Auto/manual
8
selection switch
For selecting whether to adjust the white
balance automatically or manually.
(Default setting: AUTO)
[INT/LL] Synchronization system
9
selection switch
This switch sets the synchronizing
system for the camera.
INT:
This is set for internal synchronization
LL (Line Lock):
The camera's vertical synchronization is
locked to the AC 24 V power line
frequencys.
When switching between multiple cam-
eras using a switcher, selecting this mode
and adjusting the vertical phase can
reduce the monitor sync disturbances
occur that when the camera image is
switched.
(Default setting: INT)
[WHT.BAL/PHASE] adjustment
10
selection switch
Switch to select the function of the
[R/B. +/–] adjustment button.
When setting to WHT.BAL:
When the
[AUTO/MANU] switch is
8
set to MANU, the white balance can
be adjusted using the [R/B, +/–] button.
All manuals and user guides at all-guides.com
11
When setting to PHASE:
When the
[INT/LL] switch is set to
9
LL, the vertical phase of the line lock
can be adjusted using the [R/B, +/–]
button.
(Default setting: WHT.BAL)
[R/B, +/–] adjustment button
11
This button is pressed when manually
adjusting the white balance or when
adjusting the vertical phase of the line
lock.
The function of this button is selected
using the
[WHT.BAL/PHASE] switch.
10
When manually adjusting the white
balance:
Press the R button to increase the red
tint and decrease the blue tint.
Press the B button to increase the blue
tint and decrease the red tint.
When adjusting the phase:
Press the + or – button to adjust the
phase.
[RESET] Reset button
12
When this button is pressed, the value
of the white balance or phase adjusted
manually is reset to the default value.
When the
[WHT.BAL/PHASE] switch
10
is set to WHT.BAL, the white balance is
reset to the default value. When the
switch is set to PHASE, the phase is reset
to the default value.
[SPOT CORRECTION] White-spot
13
correction buttson
When this button is pressed, white spots
are corrected.
For instructions on correcting white-
spots, see "About White-spot correction".
(
page 19)
E-7
Publicité
